TP-Link Archer C9 Quick Installation Manual

Quick Installation Guide

AC1900 Wireless Dual Band Gigabit Router
C9
Connect the Hardware
If your Internet connection is through an Ethernet cable from the wall
instead of through a DSL / Cable / Satellite modem, connect the Ethernet
cable directly to the router's Internet port, and then follow Step 1, 5 and 6
to complete the hardware connection.
Internet
Power adapter
Modem
1
Install the antennas.
Router
2
Turn off the modem,
and remove the backup
battery if it has one.
3
Connect the modem to the
Internet port on your router
with an Ethernet cable.
4
Turn on the modem and
then wait about 2 minutes
for it to restart.
Power adapter
5
Connect the power adapter
to the router and turn on
the router.
6
Confirm that the following LEDs are
on and solid to verify the hardware
connection is correct.
Power Internet
2.4G 5G
On On
On On
Note: If the 2.4G LED and 5G LED are
off, please press the WiFi button on the
side panel for 2 seconds and both the
LEDs should turn solid on in a few seconds.