Sennheiser ORL 12 Quick Start Manual

Thank you for purchasing the ORL 12 handset lifter!
After the quick and easy setup you'll be more productive than ever; free to walk,
talk, and work up to 400 feet from your desk. Check out the video setup guide at
headsets.com/support
What's in the box
Your new handset lifter includes the following
components:
1. QuickStart Guide
2. User Manual
3. ORL 12 lifter
4. Adhesive Parts
5. Connector cable
6. Extension Bar*
7. Extra ring detector with extended cord*
*Not needed for most phones
1. Connect the ORL 12 to your headset base
1. Plug the end of the included connector cord with the purple tag into the
ACC jack on the back of your headset base.
2. Plug the other end of the connector cord into your new handset lifter.
2. Attach the ORL 12 to your
desktop telephone
1. Test the placement of the lifter by
holding it to the left edge of the phone
underneath the handset and turning
the headset on and off. You'll know
you've found the right placement when
the lifter lifts the handset far enough
to open the phone line and lowers the
handset so that it hangs up the call.
2. Remove the backing from the tape
underneath the lifter. Be sure to remove
the circular tape pad that covers the
preinstalled ring detector too.
3. Remove your telephone handset and
attach the lifter to your phone.
CALL
1-800-HEADSETS (1-800-432-3738)
Connect the ORL 12 in 3 easy steps
1
ORL 12 QuickStart Guide
Don't
forget the cords
inside the
package
1
2
Remove all
tape backing
including
from the ring
detector
CLICK
www.headsets.com/support
2