Fischer mobel 1316 series Assembly Instructions

Collection Air/Swing/Modena
Assembly instructions for front extension table – Article 1314-, 1316-, 1317-, 1414-, 1416-, 1417-XX
We are delighted that you have chosen our front extension table. With this table you have purchased a high quality
product.
Due to packaging-related reasons and to ensure the product reaches you secure and error-free the table is delivered
disassembled.
Each step is clearly and very well explained. With a few hand's turns, the table can be set up easily and without
previous knowledge.
Please use a soft base (e.g. the cardboard packing) to assemble the table frame in order not to damage it.
The drawings can be found on page 2.

Scope of delivery:

- Tabletop
- Inlay board(s)
- Table frame
- Table legs incl. assembly kit – consisting of:
• Assembly instructions
• Instructions for care
• 16 x Countersunk screw M8x18
• 1 x Allen wrench SW 5
Caution:
Please note that all screws should be inserted and slightly tightened before tightening all screws firmly!
Step 1 – Preposition the table frame:
Set the table frame aside with the bottom side facing up – note stickers!
Step 2 – Prepare table legs:
Assign table legs with the pre-assembled adapter parts as shown (A, B, C, D) to the frame ends [see Drawing 1].
Step 3 – Assemble table legs:
Insert table leg with adapter into frame end and assemble with countersunk screw M8x18 (2x on top + 2x at the
bottom) using the enclosed Allen wrench and tighten firmly [see Drawing 2]. Repeat this with all 4 table legs and
subsequently place table frame on table legs.
Step 4 – Apply tabletop:
Position tabletop in centre on the locking device (release with rubber-puffer) glued to the bottom side and place on
pull-out rails [see Drawing 3]
Please note: Position the tabletop on table frame so that the fitting strip on the bottom side of the tabletop is on
the extendable part of the table frame [see Drawing 4]
Step 5 – Extend table:
Lift table frame slightly at the extendable part with both hands and pull apart [see Drawing 5]
Step 6 – Apply inlay board:
Apply inlay board in the same manner as the tabletop (watch position of the fitting strip) and push the table frame
back together by also lifting it slightly [see Drawing 6]
or
Step 7 – Store inlay board:
Place inlay board crosswise on the two braces between the pull-out rails in extended state and push table frame back
together as described above [see Drawing 7].
Check screws regularly for tightness and retighten if necessary.