Advertisement
6.
Remove the top cover:
a.
Loosen the screw on the top cover with a
T- 1 0 wrench (1).
b.
Press the latch on the top cover (2).
c.
Slide the cover toward the rear of the server
and then lift the top cover to remove it from
the chassis. Lift the top cover away from the
chassis (3).
7.
Remove the air baffle:
a.
Gently rock the air baffle up.
b.
Take the air baffle out from the system board.
8.
Find the DIMM slot for installing the new DIMM.
For P4500 G2 MDL SAS Storage products, this
is slot 6C. For all other models, it is slot 4B.
9.
Install the memory module:
a.
Align the notch on the bottom edge of the
memory module with the keyed surface of
the DIMM slot.
b.
Fully press the memory module into the slot
until the holding clips snap back in place.
CAUTION:
to ensure proper installation. If you insert
a DIMM but it does not fit easily into the
slot, you may have inserted it incorrectly.
Reverse the orientation of the DIMM and
insert it again.
10. Gently place the air baffle back on the system
board.
1 1. Reinstall the top cover:
a.
Align the top cover to the chassis and then
slide it towards the front panel to position it
into place (1).
b.
Once the cover is attached to the chassis,
tighten the screw on the top cover with a T- 1 0
wrench (2).
Page 2
The DIMM slots are structured
Advertisement
