TP-Link Archer D20 Quick Installation Manual

Ac750 wireless dual band adsl2 plus modem router

Hide thumbs Also See for Archer D20:

Connecting the Hardware

If you don't need the phone service, just directly connect the modem router to

the phone jack with a phone cable, then follow steps 3 and 4 to complete the

hardware connection.

Phone Jack

Connect the ADSL splitter

to the phone jack.

ADSL Splitter

Modem Router

Connect the modem router to the

ADSL splitter.

Connect to the phone (Optional)

Turn on the modem router.

Verify that the hardware connection

is correct by checking these LEDs.

Power On

ADSL

2.4GHz

5GHz

Note:

1. The ADSL LED

takes about 1 to 2 minutes to stabilize.

2. If the 2.4GHz LED

and 5GHz LED

are oﬀ, please press the Wi-Fi

button on the rear panel for 2 seconds, then check the LEDs again in a

few seconds.

Power Adapter

Do you have a question about the Archer D20 and is the answer not in the manual?

Page 1: Connecting The Hardware
Quick Installation Guide AC750 Wireless Dual Band ADSL2+ Modem Router Power Adapter 7106505550 REV1.0.2 Connecting the Hardware If you don’t need the phone service, just directly connect the modem router to the phone jack with a phone cable, then follow steps 3 and 4 to complete the hardware connection.
Page 2: Led Indicators
Technical Support. (USB) Flashing The USB device is being identiﬁed. Oﬀ No USB device is plugged into the USB port. Note: For advanced settings, please refer to the User Guide on TP-LINK oﬃcial website at www.tp-link.com. ©2015 TP-LINK...