Pilotfly H1 SE Quick Manual

PILOTFLY H1 Plus
Height: 310 mm
Width:150 mm
Depth: 150 mm
Weight: 890 g
Camera tray size
Height: 110 mm
Width: 140 mm
Maximum supported weight
Camera : 1500 g
Maximum offset
On pan: 355°
On tilt: 355° , +/-180° during work
On roll: 355° , +/-60° during work
Power
Power supply: Bulid-in Rechargeable Lithium Polymer 4-cell
14.8V 1800mAh battery
Operation time: 60 to 210 minutes
(depends on settings and actual camera weight)
Electronics
Main board: Custom AlexMos 3-axis SimpleBGC 32bit
Dual IMU sensor
Connectivity: Mini-USB
Control Mode: Default 3 use mode
繁體中文
English
Full manual download from Qrcode
SE
QuickGuide
Facebook:
www.facebook.com/pilotflytech
Technical support via e-mail:
info@pilotfly.de
yanherlin@gmail.com
CONNECTING
Bluetooth
ID: PILOTFLY
Password: 1234
Parameters by SimpleBGC GUI
Parameters & Remote control
by SimpleBGC Mobile APP
(Google play)
DC-IN
LED
RED:
Charging
LED Green:
Charged
Connect to extender battery
16.8V 1A
Charger
CAMERA
INSTALL
&
BALANCE
. 2.
1
Loosen up all marked M4 screws.
Attach the camera to the
PILOTFLY H1 and fix it with the
1/4 screw.
5. 6.
Adjust tilt axis (vertical). Balancing the Pan:
Rotate the tilt axis that the Hold the device as shown on
camera lens is pointing straight the picture and check the
up. Shift the camera till it is balance of the pan axis.
balanced and tighten up the
marked screw.
Handheld 3AXIS Stabilizer for Mirrorless camera
2
2
Micro USB
PC/NB
Parameters by SimpleBGC GUI
No charge function
Not included
4S 14.8V LiPO
3. 4.
Shift the camera to balance Adjust tilt axis (vertical).
and adjust the tilt axis and Rotate the tilt axis that the
tighten the 1/4 screw. camera lens is pointing straight
up. Shift the camera till it is
balanced and tighten up the
marked screw.
7. 8.
Shift the L-arm of the pan axis Ensure proper fixation and
then tighten up the marked double check all screws again.
screws. Tighten up if necessary.