PRESONUS EarMix 16M Owner's Manual page 16

2 Getting Started
2.2 Using a StudioLive Classic- or AI-series Front-of-House mixer
Step 1: Route Your Audio
In our example, we will only be using six of the StudioLive 32.4.2AI's aux mix
outputs, leaving the remaining six available for other uses (external effects
processing, overflow rooms, subwoofer networks, etc.). We will also be
connecting the direct outputs for Channels 1-2, 15-17, and 24 as follows:
StudioLive 32.4.2AI Output
Aux Mix 1
Aux Mix 2
Direct Out 1
Direct Out 2
Aux Mix 5
Direct Out 15
Direct Out 16
Direct Out 17
Aux Mix 3
Aux Mix 4
Aux Mix 6
Direct Out 24
Power User Tip: The PreSonus SW5E AVB Switch provides PoE (Power over Ethernet) on
ports 2-5. When connecting your EarMix 16M to these ports, you do not need to connect
the external power supply that came with your unit. Please Note: You must use the AVB In
port to power your EarMix 16M over Ethernet. The AVB Thru port does not accept input
power.
Note: This hook-up diagram shows the StudioLive 32.4.2AI, the same setup can be used
for either StudioLive Classic mixer (16.4.2 or 24.4.2) and any StudioLive AI-series console
mixer (16.4.2AI, 24.4.2AI, or 32.4.2AI). Because the StudioLive 16.0.2, 16.0.2USB, RM/
RML16AI, and RM/RML32AI do not feature direct outputs, you will need to route every
input to an aux mix similar to what is described in Section 2.1.
Variations on this setup can also be used to integrate EarMix 16M
Monitor Mixers with third-party analog and digital mixers.
1. Launch Universal Control on the device that is connected to your StudioLive 16R.
2. Select the StudioLive 16R from the device list.
3. Click or Tap on the Settings Gear.
4. Click or Tap on the Networking tab.
StudioLive 16R Input
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input 7
Input 8
Input 9
Input 10
Input 11
Input 12
EarMix 16M
Owner's Manual
14