Transposing The Pitch; Switching The Pedal Function; Tuning; Listening To The Demo Performance - Roland C-30 Quick Manual

Transposing the pitch

By holding down [Temperament], pressing [Organ I], and then pressing any key other than
C while you continue to hold down these two buttons, you can transpose the pitch of the C-
30 so that the key you pressed will be the root key.
At this time the [Temperament] indicator will light red.
To cancel transposition, hold down the [Temperament], press the [Organ I], and while con-
tinuing to hold down these two buttons, and press the C key. The [Temperament] indicator
will go out and the pitch will return to normal.

Switching the pedal function

If the included pedal is connected, you can use it as a damper pedal to extend the sustain, as
on a piano. You can also use the pedal to switch sounds.
For example, if you select the [Lute] sound, and then hold down [Function] and press
[Organ II], the [Organ II] indicator will light green, the [Lute] sound will be stored, and the
pedal function will change to switching sounds.
Next, switch the sound to [8' I] and then press the pedal; while you continue holding down
the pedal, the sound will instantly switch to the [Lute] sound you stored earlier, thus letting
you use the pedal to switch between different sounds (or combinations of sounds) even
while you perform.
If the [Organ II] indicator is already lit green when you press [Function], you can hold down
[Function] once again and press [Organ II] to make the [Organ II] indicator go out, returning
the pedal to the damper pedal function.
If you want to store a different sound and use the pedal to switch sounds, hold down [Func-
tion] once again and press [Organ II] to make the [Organ II] indicator light green.

Tuning

By holding down [Function] and turning the Tone knob you can adjust the overall pitch of
the C-30.

Listening to the demo performance

If you press [Function] and [Temperament] simultaneously, the built-in demo songs will
begin playing.
To switch songs, press the lit sound button or press one of the other sound buttons whose
indicator is blinking.
[Organ I] will stop playback or move you to the beginning of the song, and [Organ II] will
pause or play (restart) the song playback.
Press [Function] to exit demo mode.
* See "Demo Song List" in the Owner's Manual.

Adjusting the volume of the harpsichord's distinctive noise

By holding down [Temperament] and turning the [Volume] knob, you can temporarily
adjust the volume of the attack noise that is heard when you play a key strongly.
By holding down [Temperament] and turning the [Reverb] knob, you can temporarily
adjust the volume of the noise that is heard when you take your finger off a key.
Both of these settings will return to their original state the next time you turn on the power.
Copyright © 2008 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in
any form without the written permission of ROLAND CORPORATION.
* 4 0 7 8 5 1 3 4 - 0 1 *
40785134 08-02-1N