Checking cold start valve
1. Remove cold start valve (26) and check bushing for wear.
2. Metering disc (23) must be free of marks. Check that the disc has axial freedom on the shaft, but no
rtadial play.
3. Mount cold start valve assy. Apply a small amount of CURIL-T to the screw facing the floatchamber.
Notice:
This document has been translated to the best of our knowledge. In case of doubt, however, only the
German original shall be considered as authoritative.
Bearb.: Stolinski
Gepr. + Freig.:
Maintenance Instruction
Replaces edition from: 13.09.96
Edition: 18.12.02
Page: 3 of 3 Pages
Reg.-Nr.: 041 Datei:
MI10-3.DOC
10.3