Signal Flow (Block Diagram) - Roland SP-555 Owner's Manual

Introducing the SP-555
8.
PEDAL Jack
You can connect a pedal switch (DP series; sold
separately) here and use it to perform loop capture or
pattern play/stop operations (p. 68).
9.
LINE IN Jacks (L/R)
Connect these jacks to the audio source device from which
you want to sample, such as a CD player or portable

Signal flow (block diagram)

D BEAM SYNTH
SAMPLER
USB AUDIO
from PC
(*1)
LINE IN / MIC
*1: USB Audio Input. To mute this, hold down [CANCEL], press [MIC], and operate the CTRL 3 knob.
*2: D Beam Synth send to Effect. To turn this on, hold down [EFFECT ASSIGN] and press [SYNTH].
*3: USB Audio send to Effect. To turn this off, hold down [EFFECT ASSIGN] and [CANCEL], and press [MIC]/[LINE IN].
*4: Mic/Line In send to Effect. To turn this off, hold down [EFFECT ASSIGN] and press [MIC]/[LINE IN].
*5: USB Audio output source SW. To change this setting, hold down [CANCEL], press [LINE IN], and operate the CTRL 3 knob.
14
SAVE TO PAD
SAMPLING / RESAMPLE
(*2)
EFFECT
(*3)
(*4)
audio player.
10.
LINE OUT Jacks (L/R)
Connect these jacks to your audio system, amp, or mixer.
11.
Security Slot (
http://www.kensington.com/
LOOP CAPTURE
D BEAM
FILTER
METRONOME
)
LINE OUT /
PHONE
(*5)
USB AUDIO
to PC