Hochiki SLR-24 Installation Instructions

CAUTION
Install the bases in this instruction in accordance with applicable
NFPA standards, local codes, and the authorities having
jurisdiction. Failure to follow these instructions may result in
failure of the detector to initiate an alarm condition. Hochiki
America is not responsible for detectors that have been
improperly installed, tested, or maintained.
For testing and cleaning information, refer to Page 2 of these instructions and
to Technical Bulletin HA-97 Conventional. Also refer to NFPA-72 Chapters 2
and 7 for Automatic Fire Detector installation guidelines, testing, and
maintenance.
Use "3M" Weatherban # 606 non-flammable sealing compound to seal
field wiring conduit openings in the mounting back box. Compliance with
this request may reduce the occurrence of the "STACK EFFECT".
SPECIFICATIONS
DETECTORS
SIJ-24/-24C
IONIZATION
TYPE OF DETECTOR
15-33.0 VDC
WORKING VOLTAGE (2-WIRE)
RATED VOLTAGE (4-WIRE) 17.7-30.0 VDC
FILTERED DC
VOLTAGE WAVEFORM
5V RIPPLE MAX.
150 mA
MAX. ALARM CURRENT
MAX. SURGE CURRENT
AVERAGE STANDBY CURRENT
HEAT ELEMENT RATING
COMPATIBILITY IDENTIFIER
NSTT-A100
SENSITIVITY TEST DEVICES
30/ZONE
HCP-1008E CONTROL PANEL
Note: The SLR-24V, SLV-24V and SOC-24V are suitable for installation in air velocities up to 4000ft./min.
6
5
NS6 SERIES
(EXCEPT NS6-100)
DSC-EA HEAT DETECTORS
SPECIFICATIONS
DETECTOR MODEL
DETECTOR TYPE
TEMPERATURE RATING
MAX. ALARM CURRENT
UL LISTED TEMPERATURE
OPERATING TEMPERATURE
DFE HEAT DETECTORS
SPECIFICATIONS
DETECTOR MODEL DFE-135/-135W/DFE-135C
DETECTOR TYPE FIXED TEMPERATURE
TEMPERATURE RATING
MAX. ALARM CURRENT
COMPATIBLE
UL LISTED
CONTROL
PANEL
PANEL
POWER
SUPPLY
NEGATIVE
HOCHIKI AMERICA CORPORATION
7051 VILLAGE DRIVE SUITE 100
BUENA PARK, CA 90621-2268

INSTALLATION INSTRUCTIONS

These instructions apply to all Hochiki America detector bases that utilize an NS detector with LEDs to
indicate power, and alarm.
SMOKE DETECTOR DATA
SLR-24/-24C/-24V/-24VC
-24VN/-24H/-24HC
PHOTOELECTRIC PHOTOELECTRIC
15-33.0 VDC
17.7-30.0 VDC
*
*
FILTERED DC FILTERED DC
5V RIPPLE MAX. 5V RIPPLE MAX.
150 mA
200 A
160 A
40 A
45 A
N/A
135°F(SLR-24H only)
HD3
HD3
BUILT-IN
TEST FEATURE
30/ZONE
6
5
NS6-100
HEAT DETECTOR DATA
DSC-EA/DSC-EAW
RATE OF RISE
15°F./MIN.
100 mA
0°C ~ 37.8°C
(32°F ~ 100°F)
-10°C ~ 50°C
(14°F ~ 122°F)
HEAT DETECTOR DATA
DFE-190/-190W/DFE-190C
FIXED TEMPERATURE
135°F. 190°F.
100 mA 100 mA
L4
L3
L3L4
H2
S1
H1
S2
L2 L1
L1
L2
Pig Tail Lead
HSC-220L
FIG. 2
DCD-135/-135W/-135C
SLV-24V/-24N
-190/-190W/-190C
-24NW/SLV-24
FIXED TEMP/RATE-
OF RISE HEAT
15-33.0 VDC 15.0-33.0VDC
17.7-30.0 VDC
17.7-30.0VDC
*
FILTERED DC
5V RIPPLE MAX.
150 mA 150 mA
160 A 160 A
45 A
35 A
N/A 135/190°F
HD3 HD3
BUILT-IN
TTA-1H
TEST FEATURE
30/ZONE
30/ZONE
BASE STYLES
1 2
NS4 SERIES
(4 INCH BASE)
(EXCEPT NS4-100)
BASE MODEL
HSC-224L/-224LW
HSC-220L/-220LW
HSC-221L/-221LW
NS4-100,100W
NS6-100,100W
NOTE: BASES/DETECTORS WITH THE "W" SUFFIX ARE WHITE IN COLOR.
NOTE: BASES/DETECTORS WITH THE "C" SUFFIX ARE CANADIAN.
NS6 SERIES
(EXCEPT NS6-100)
FIG. 1
BOX MOUNTING
BASE
3" OCT
YES
NS4-BASE
NS6-BASE NO
HSC-BASE NO
Connect wiring to the bases as shown in the wiring diagrams that
follow. Detectors and bases may be mixed on the same initiating
loop as long as the number of two-wire powered detectors does not
exceed the specifications of the control panel (see Figure 2 below)
CAUTION
CONNECT WIRING TO TERMINALS AS SHOWN.
DO NOT LOOP WIRE UNDER TERMINALS.
BREAK WIRE RUN TO PROVIDE SUPERVISION
OF CONNECTIONS.
SLR-835/-835W/ SLR-835H/-835HW
-835C
PHOTOELECTRIC PHOTOELECTRIC
8.0~35.0 VDC 8.0~35.0 VDC
8.0~35.0 VDC 8.0~35.0 VDC
*
*
FILTERED DC FILTERED DC
15% RIPPLE MAX. 15% RIPPLE MAX.
150 mA 150 mA
200 A 200 A
38 A @ 12 VDC 38 A @ 12 VDC
55 A @ 24VDC 55 A @ 24VDC
70 A @ 35VDC 70 A @ 35VDC
N/A 135°F
HD5 HD5
BUILT-IN BUILT-IN
TEST FEATURE TEST FEATURE
30/ZONE 30/ZONE
NOTE:
When mounting detector on
a wall, it must be between 4"
and 12" from the ceiling.
1 2
NS4-100
(4 INCH BASE)
ALARM CURRENT
35~42 mA @ 24V
(54 mA MAX.)
67~80 mA @ 24V
(88.5mA @ 26.5VDC MAX)
37~45 mA @ 24V
(57mA MAX)
NON-CURRENT
LIMITED
NON-CURRENT
LIMITED
2
1
4
6 5
3
NS6-100
4" OCT 4" SQR
NO NO
YES YES
YES YES
SOC-24V/-24VN
SOC-24VW
PHOTOELECTRIC
8.0~35.0 VDC
8.0~35.0 VDC
*
*
FILTERED DC
15% RIPPLE MAX.
150 mA
160 A
59 A
N/A
HD3
BUILT-IN
TEST FEATURE
30/ZONE
* When using a four-wire
base full wave rectified
AC can be used.
L4
L3
H2
S1
H1
S2 L2 L1
HSC SERIES
LATCHING
COMPATIBILITY
IDENTIFIER INDICATION
HB-62 YES
YES
HB-64
HB-63
YES
NO
N/A
N/A
NO
LISTED
END OF LINE
DEVICE
DWG. # HA-06-060
(Pg.1 of 2, 06/16)
PART# 1700-09987