Changing The Metronome Sound; Applying Effects To The Sound; Adding Reverberation To The Sound (Reverb); Changing The Amount Of Effect Applied - Roland MP-60 Owner's Manual

Chapter 2. Performance

■ Changing the Metronome Sound

1
Hold down the [BEAT] button and press the [+] or [-] button.
The metronome will sound, and the currently specified sound number will displayed.
2
Continue to hold down the [BEAT] button, and press the [+] or [-] button
once again.
The metronome sound will change.
Display
t. 1
t. 2
t. 3
t. 4

Applying Effects to the Sound

fig.panel2-5
1

■ Adding Reverberation to the Sound (Reverb)

By applying the reverb effect you can produce a pleasant reverberation, making it
sound as though you were performing in a concert hall.
1
Press the [REVERB] button.
The button's indicator will light, and a reverb effect will be applied to the sound.
To cancel the reverb effect, press the [REVERB] button, getting its indicator to go
dark.

■ Changing the Amount of Effect Applied

The depth of the reverb effect can be adjusted over eight steps.
Changing the depth of the reverb effect
1
Hold down the [REVERB] button and press the [+] or [-] button.
The currently specified value will be displayed.
2
Continue to hold down the [REVERB] button, and press the [+] or [-]
button once again.
The depth of the reverb effect will change. Higher values will produce a deeper
effect.
16
beat
Ordinary metronome sound
Dog and cat cries
A voice counting "1, 2, 3" in English
A voice counting "1, 2, 3" in Japanese
This is set to "t. 1" when the
instrument is turned on.
When you hold down the
[BEAT] button, the currently
specified sound number will be
displayed.
When an internal song is
played back, the metronome
sounds the ordinary
metronome sound.
When a recorded performance
is played back, the metronome
sounds the sound that was
selected when the recording
was made.
The reverb effect setting for
each tone is not remembered.
When you play back an
internal song, the reverb effect
will automatically be turned on
(the button's indicator lights).
When the power is turned on,
reverb is set to "4."
When you hold down the
[REVERB] button, the
currently specified reverb
depth value will be displayed.
The depth of the reverb effect
for each tone is not
remembered.