Advertisement
will increase the frequency changing speed.
3. Press SELECT button to accept the start frequency.
4. Press UP and DOWN button to set the stop frequency, which is the highest frequency of
automatic scanning range. Push the SCAN button at the same time with UP or DOWN button
will increase the frequency changing speed.
5. Press SELECT button to start frequency scanning.
6. The AW06A SWR Analyzer will then scan the entire frequency range set above and stop on
the frequency with the lowest SWR. The LCD will show the frequency, SWR and the
impedance.
7. Tap QUICK button while the Analyzer scanning will stop the scan procedure then display the
SWR and impedance on the stopped frequency.
8. Tap SCAN button again to enter manual scan mode, the 'A ' character on the right bottom
corner will disappear and you are able to change the measurement frequency by pushing UP
and DOWN buttons.
9. Press SELECT button if you want to go back to the automatic scan mode.
http://featuretech.co.nz
Ham Accessories
Advertisement
