Touch Pad; Reading The Display; Powering On Or Off The System; Controlling The Volume - Bose WAVE IV Owner's Manual

Using the System

Touch pad

The system has a touch-sensitive control pad on the top panel.
Momentarily placing your hand on the touch pad can power on or
off the system, snooze a sounding alarm, and reset it for the next
day (see page 12).
Notes:
• Press-and-hold operations require holding the button down for
about one second.
• Pressing , , or
the selected source.

Reading the display

Source indicators: CD, FM, AM, or AUX
Play mode
Clock
Source or system-related information

Powering on or off the system

• Press on the remote control
or
• Touch the touch pad.
The last source you were listening to is active.
Alternatively:
Press any source button to power
the system on to that source.
Notes:
• Selecting AUX does not power on a device connected to AUX IN
(such as a media player). Power on the device first.
• After 24 hours of no button presses, the system switches to
standby (off). If the 20-minute system standby timer (page 15)
is enabled, the system switches to standby if no audio is played
and no buttons are pressed for 20 minutes.
8 - English
automatically powers on the system to
Alarm status
®

Controlling the volume

Press and hold
VOLUME - 0 (silent) to 99 (loud) appears on the display to
indicate the level.
Press to mute the system.
Press again, or press
While muted, you can press
unmuting the system.
Note: When the system is off, the volume can only be adjusted
between 10 and 75.

Setting the Sleep timer

Press SLEEP to set the system to shut off after a selected
period of time.
• After pressing SLEEP, SLEEP - 30 MIN (or your last setting)
appears on the display and the sleep timer begins counting
down. If the system is off, press SLEEP to power on and
immediately set the sleep time. The last source selected will
start playing as the sleep timer counts down.
• While the SLEEP setting is displayed, press SLEEP again to
set the sleep timer to 10-90 minutes (in 10-minute increments)
or OFF.
Note: If more than 10 seconds elapses between button
presses, the system automatically exits the sleep timer
setup mode.
• To review the remaining sleep time, press SLEEP.
• To cancel the sleep timer, press and release SLEEP until
SLEEP - OFF appears on the display.
or to adjust the volume level.
to unmute.
to lower the volume before