Quick Start; Getting Ready - Boss Vocal Performer VE-20 Owner's Manual

Quick Start

1.

Getting ready

Connect your mic to the INPUT jack, and connect
1
the OUTPUT jacks to your mixer or recorder.
Move the rear-panel POWER switch to the ON
2
position. (The power will turn on.)
Adjust the input sensitivity.
3
In order to use the VE-20 optimally, you'll need to adjust the
input sensitivity.
1. Press the MENU button.
2. Press the cursor button (
3. Turn the SOUND knob to adjust MicSens.
At the ideal setting, the meter will occasionally reach the
far right (as shown below) when you sing loudly. If your
voice sounds distorted, lower the MicSens setting.
4
Before you make connections, make
sure that the input gain or volume of
your mixer or recorder is turned
down.
) to select MicSens.
Meter
• If you're using batteries, insert them
before you continue.
"Installing Batteries" (p. 3)
• If you're using an AC adaptor (BOSS
PSA-series; optional), connect it to
the DC IN jack.
• If you use a condenser mic that
requires phantom power, set the
Phantom Power parameter to the
On.
"Using a condenser mic
(Phantom Power)" (p. 16)
• If you're using headphones,
connect them to the PHONES/LINE
jack.
When you turn on the power, a screen
like the following will appear. This is
called the "Play screen."
Lit
The MicSens setting is stored in memory
even after the power is turned off, so you
won't need to adjust it again unless you
want to use a different mic or a different
vocalist.