Advertisement
General Guidelines
• It is the user's responsibility to read and follow all instructions.
• Keep these instructions with the product at all times and review before each use.
• It is the responsibility of this product's owner to furnish the instructions to any person that borrows
or purchases the product.
• Inspect the product before use to ensure it is assembled properly and all parts are in safe working
order and free of defects.
• Never modify this product in any way.
• All circumstances cannot be addressed in these instructions. Please use common sense and prac-
tice general safety measures when using this product.
• Parts and/or instructions are subject to change without notice.
Safety
• Do not exceed the carrying capacity of 600 lbs.
• Never exceed the maximum tongue weight rating of your trailer hitch (check the weight sticker on
the trailer hitch).
• Check with the vehicle dealer or manufacturer to determine the carrying/hauling capacity of your
vehicle.
• Total hauling weight is calculated by adding the total weight of the motorcycle + 99 lbs (MX-600X
weight).
• Some vehicles may require air shocks or heavier springs to stiffen up the suspension to prevent
sagging.
• Not for use with 1-1/4" Class II or smaller receivers.
Tools Required
• 13mm wrench
Rev. 061318
Steel Motorcycle Carrier
Instructions for Part# MX-600X
• 17mm wrench
DiscountRamps.com • 1-888-651-3431
Page 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Black Widow MX-600X
Summary of Contents for Black Widow MX-600X
- Page 1 • Check with the vehicle dealer or manufacturer to determine the carrying/hauling capacity of your vehicle. • Total hauling weight is calculated by adding the total weight of the motorcycle + 99 lbs (MX-600X weight). • Some vehicles may require air shocks or heavier springs to stiffen up the suspension to prevent sagging.
- Page 2 Parts Part Description Quantity Part Description Quantity Main Hitch Tube M10 Eye Bolt Ramp Holder Bracket Wing Nut Carrier Support Bracket M10 Nut Ramp M8 Nut Carrier Track Anti-Tilt Bracket Reflector Sticker Pinch Bolt M10x70 Bolt Long Pin with Spring Clip M8x45 Bolt Hitch Pin M8x20 Bolt...
- Page 3 Step 4. Place the ramp (D) onto the main hitch tube and ramp holder bracket and se- cure it using three wing nuts (K). Tighten the two bolts on the ramp holder bracket. Step 5. Slide the long pins (P) into the sides of the carrier track and secure them with spring clips.
- Page 4 Product Warranty and Liability GENERAL PRODUCT WARRANTY: Products purchased from the Authorized Dealer (original place of purchase) or Merchant (“Dealer”) will be free of defects in material and workmanship at the time of receipt, and will meet the specifications stated at the place of purchase transaction or online at the Dealer’s website, under normal use and service when correctly installed, operated and maintained.
Need help?
Do you have a question about the MX-600X and is the answer not in the manual?
Questions and answers