Rimage 2000i Series II User Manual page 11

Operate the Rimage 2000i Series II
This section includes information about how to power on and off the Rimage
2000i, pause the system, and load discs. It also provides instructions for
setting your printing preferences.
Power On the Rimage 2000i
Important! You must power on the Rimage
2000i before you power on the PC. If
the PC starts before the Rimage 2000i is
powered on, your operating system will
not recognize the autoloader and it will not
initialize properly.
Press the power switch on the back of the
Rimage 2000i. The power indicator light
illuminates solid green.
Power Off the Rimage 2000i
Press the power switch on the back of the Rimage 2000i. The power
indicator light dims.
Pause the Rimage 2000i
Before you load or unload discs, you must pause the Rimage 2000i.
1. Press and release the
operator button to pause the
autoloader. [RIMAGE 2000i
PAUSED...] displays on the
operator panel.
2. Press the operator button
again to return to normal
operation.
2002760_A
Power Switch
Operator Button
For more information visit
Load Discs
The supply bin holds up to 100 discs. Use discs that are coated with an ink-
jet printable surface. The media in Rimage Media Kits™ are designed for
optimum print performance.
Use the following procedure to load discs into the supply bin.
1. Press and release the
operator button to pause the
Rimage 2000i.
2. Gently move the disc diverter
to the right.
3. Place the discs in the supply bin so the recording side faces down.
Important! Hold the discs by
the edge. Fingerprints on the
disc surface can affect print
quality.
Tip: Separate the media to
make sure that the discs do
not stick together.
rimage.com/support
Disc
Diverter
8