TeeJet 844 Operation Manuals

System Setup Mode

• The Master boom switch must be off. Press (+) and (-) keys while simultaneously pressing the
key. Press the
Step Display
Units
US, TRF
Flowmeter
Pulses
Nozzle
Spacing
Tips per boom
section 1
Tips per boom
section 2
Tips per boom
section 3
Tips per boom
section 4
Tips per boom
section 5
User
Programmabl
e Tip
Pressure
Regulating
Mode
2 Way or
Boom Control
Valve Type
3 Way
Liquid
Density
Speed
Calibration
• To exit the System Setup mode, press and hold
process.
Spraying Systems Co.
844 Operations Mini Manual
key again to enter the System Setup Mode.
Description
Select US or Turf units by using + and - buttons
Go to next step with
Flow Meter Pulses
Value from flowmeter tag
Go to next step with
Nozzle Spacing
Distance between tips in inches
Go to next step with
# of tips on Boom sect. 1 (corresponds to switch #1)
Enter 0 if not used. Go to next step with
SEC 1
Tips on Boom sect. 2. Enter 0 if not used.
Go to next step with
SEC 2
Tips on Boom sect. 3. Enter 0 if not used.
Go to next step with
SEC 3
Tips on Boom sect. 4. Enter 0 if not used.
Go to next step with
SEC 4
Tips on Boom sect. 5. Enter 0 if not used.
Go to next step with
SEC 5
Flow rate in Gallons Per Minute of tip being
programmed at 40 psi. Use + and - keys to adjust
P
flow rate. Go to next step with
In low flow situations, BYP is the preferred mode.
Use the + and - keys to change to THR mode if the
regulating valve is mounted in the supply line. Go
to next step with
Boom Shutoff Valve Type
Standard (2-way on-off) or Bypass (3-way bypass)
Go to next step with
1.0 for water. See chart in manual for other
D
materials. Go to next step with
Speed Calibration. Change with + and -, or to auto
calibrate press + and - simultaneously to clear value,
then drive 300 feet and press
button
button
button
button.
button.
button.
button.
button
button.
button
button
.
for 3 seconds at any point in programming
My Values
button.
10/12/1995 12:47 PM