Extron electronics WPD 110 A Installation Manual

WPD Series Wallplates • Installation Guide
The Extron WPD Series (WPD 110 A, WPD 120 A, WPD 130 A, and WPS 140A) are single gang
pass-through wallplates with HDMI, DisplayPort, DVI, or VGA connectors and pigtail mounted
rear connectors. All models can be installed in single gang junction boxes, and include a
decorator-style frame. The models are as follows:
A B C
e
WPD 110 A
• WPD 110 A — HDMI, stereo audio, and control
HDMI female to HDMI female connector on a pigtail
•
3.5 mm stereo audio jack with 3-pole captive screw connector
•
3-pole captive screw connector (for pass-through signals such as IR and RS-232)
•
• WPD 120 A — DisplayPort, stereo audio, and control
DisplayPort female to DisplayPort female connector on a pigtail
•
3.5 mm stereo audio jack with 3-pole captive screw connector
•
3-pole captive screw connector (for pass-through signals such as IR and RS-232)
•
WPD 130 A — DVI, stereo audio, and control
•
DVI-I female to DVI-I female connector on a pigtail
•
3.5 mm stereo audio jack with 3-pole captive screw connector
•
3-pole captive screw connector (for pass-through signals such as IR and RS-232)
•
• WPD 140 A — VGA, stereo audio, and control
15-pin VGA female connector on a pigtail
•
3.5 mm stereo audio jack with 3-pole captive screw connector
•
3-pole captive screw connector (for pass-through signals such as IR and RS-232)
•
Install the wallplate directly into the wall using the supplied mud ring or a UL-approved 1-gang
junction box (not supplied). Follow the steps in the "Installation" section on page 2.
Planning -
Check the Proposed Installation Location
Before starting the installation it is important that you do the following:
CAUTION:
• Failure to check the items listed below may result in personal injury.
• La non-vérification des éléments listés ci-dessous peut provoquer des blessures.
ATTENTION:
Ensure there are no utility cables or pipes at the intended location that might be damaged
…
or cause injury when you are installing the device.
Check that the installation meets the local and state regulatory requirements, including
…
building, electrical, and safety codes, and UL and ADA accessibility requirements.
DISPLAYPORT
A B C
e
WPD 120 A
Failure to check the items listed below may result in property damage.
DVI
A
B
C
e
WPD 130 A WPD 140 A
COMPUTER
A B C
e
Side View