Table of Contents
Advertisement
HDElity HDMI EDID reader/writer with HDCP support
Hardware Installation
1. Read the EDID from a HDMI display manually
1.
Connect the display device to the EDID Reader/Writer/Re-timer via Monitor-HDMI port.
2.
Plug in the 5V DC power supply unit.
3.
Set 104026 to the mode 6.
4.
The EDID reading sequence is done when the green LED lights off.
5.
Switch the rotary switch back to mode 0 ~ 4.
2. Read the EDID from a HDMI display via software
1.
Set 104026 to the mode 7.
2.
Connect the display device to the EDID Reader/Writer/Re-timer via Monitor-HDMI port.
3.
Plug in the 5V DC power supply unit.
4.
Connect the 104026 to the serial port of PC.
5.
Click on "HDMI Monitor Reader" button to read the EDID information from HDMI display.
6.
The EDID reading sequence is done when the green LED lights off.
3. Write an EDID to the HDMI display
1.
Set 104026 to the mode 7.
2.
Connect the display device to the EDID Reader/Writer/Re-timer via Monitor-HDMI port.
3.
Plug in the 5V DC power supply unit.
4.
Connect the 104026 to the serial port of PC.
5.
Click on "HDMI Monitor Writer" button to write the EDID information to HDMI display.
6.
The EDID reading sequence is done when the green LED lights off.
*The EDID Reader/Writer/Re-timer may not work on the monitors with EDID write-protection.
6
Advertisement
Table of Contents
