Advertisement
2.
Connect the modem to a free USB port on your Barracuda NextGen Firewall F by using the included
USB extension cable.
Note: The firewall appliance needs to be powered off, as otherwise the modem driver will
not be initialized.
3.
Connect the external antennas to the ANT 1 and ANT 2 interfaces of the modem. The external
antennas are equipped with a magnetic base thus allowing for convenient placement on racks or
any other metal surfaces.
4.
Deploy the modem with a standard cap rail.
5.
Power on the Barracuda NextGen Firewall F and modify the WWAN network settings by navigating
Configuration
Network
Wireless WAN
to
>
>
6.
Select the WWAN Active checkbox.
7.
Enter the Access Point Name of the provider (available from the provider).
8.
Enter the SIM PIN number (if PIN needed).
9.
Enter the Phone Number for dial-in (available from the provider).
Barracuda Networks, Inc. 3175 S. Winchester Blvd, Campbell, CA 95008 USA • phone: 408.342.5400 • fax: 408.342.1061 • www.barracuda.com Copyright 2004-2017© Barracuda Networks, Inc. All rights reserved. Use of this product and this
manual is subject to license. Information in this document is subject to change without notice. Barracuda Backup is a trademark of Barracuda Networks, Inc. All other brand and product names mentioned in this document are registered
Page 2
trademarks or trademarks of their respective holders. 31072017 v.30
.
Barracuda 3G USB MODEM M30a - Quick Start Guide
10. Commit Changes
To commit all previously done configuration steps, the new configuration needs to be
activated at the Barracuda NextGen Firewall. Click
11. Network Activation
Control
Box
Go to
>
and click
Network
section. Click Failsafe in the appearing Network Activation pop-up window. Wait for
the Activation Succeeded dialog, and then click OK.
Note: Due to network activation you may lose connection to the appliance.
Select Reconnect (upper right) to reconnect to the appliance.
Control
Network
12. Navigate to
>
13. In order to restart, switch-off, or stop the WWAN connections, navigate to
Control
Box
Dynamic Networks
>
>
For further details and product documentation, please visit:
Send Changes
followed by
Activate new network configuration
within the
and check the availability of the WWAN uplink (ppp5)
.
https://campus.barracuda.com
Activate
.
Advertisement
