Barracuda Networks M10 Quick Start Manual

Thank you for purchasing the M10 Barracuda USB Modem which conveniently provides support for wireless broadband communication using
3G/UMTS/HSDPA/HSUPA technologies. The modem supports bandwidths up to 7.2 Mbps and thus provides a cost effective alternative to xDSL and ISDN uplinks or
failover lines.
Note: SIM card is not included and has to be obtained independently through your cell phone provider.
Packaging Content:

One USB Modem

One USB Cable

One external Antenna

One Quick Start Guide
Please contact Barracuda Networks Support if any of these items is missing.
Modem Specifications:
Frequencies (MHz) GSM 850/900/1800/1900
UMT S850/1900/2100
UMT S2100
Output Power Class4 (+33dBm ±2dB) for EGSM900
Class 1 (+30dBm ±2dB) for GSM1800
Class E2 (+27dBm ± 3dB) for GSM 900 8-PSK
Class E2 (+26dBm +3 /-4dB) for GSM 1800 8-PSK
Class 3 (+24dBm +1/-3dB) for UMTS 2100, WCDMA FDD BdI
Supported Data Transmission HSUPA
HSDPA
3G
UMTS
EDGE
SIM Interface 3VDC 6 pin
Power Supply 5 VDC via USB Interface
USB Interface USB 2.0
Dimensions (LxWxH mm) 71 x 49 x 20
Net Weight (g) 150
0 °C – 40 °C
Operation Temperature
Certifications FCC, CE, ROHS
Interface SMA
Frequency Range (MHz) 800-2800
Input Impendence (Ohm) 50
Gain (dBi) 3.5
Polarization Type Vertical
Radiation Direction Omnidirectional
VSWR <1.5
Max. Input Power (W) 50
Length (mm) 260
Cable Length (mm) 3000
Page 1
USB Modem
Antenna
Barracuda M10 USB MODEM - Quick Start Guide
Overview:
1. SIM Tray
2. SIM Tray Lock (open SIM Tray by pressing the lock with a pen)
3. USB Interface
4. Headphone Jack
5. LED 1 (green)
6. LED 2 (red)
7. SMA Antenna interface
The Status LEDs:
Your Barracuda M10 USB-Modem is equipped with two status LEDs which indicate the operational
state of the modem by changing between off, slow blinking, fast blinking and steady glowing. The
table below shows the different meanings of the different glowing states:
LED 1 LED 2
- RED
GREEN -
GREEN -
GREEN RED
GREEN RED
Getting Started
1) Open the SIM card tray by carefully pressing on the tray lock which is situated next to the tray,
ideally by using a pen. Remove the SIM card tray and place the SIM card in the tray.
State Meaning
Steady SIM card missing, no
PIN set, not in Provider
net, ERROR
Blinking Successful 3G/UMTS
connection with
provider established
Fast Blinking Data transfer using
3G/UMTS uplink
Blinking Successful EDGE
connection with
provider established
Fast Blinking Data transfer using
EDGE uplink