Advertisement
NCM-OR-200
4 Channels Optical Receiver
Front Panel:
The front panel is shown in Figure.
Power LED- Lights up when the key is turned on.
1-
RF LED ALARM-Lights up green when the output RF power is ok or red when out of range.
2-
PD LED ALARM- Lights up green when the input optical power is ok or red when out of range.
3-
4- Power On Key- Turns on/off the power
LCD- Information Display
5-
U, D, R and F key- Four key from key-board
6-
OPTICS
MODEL OR-200
Rear Panel:
The Rear Panel is shown in Figure.
RF Output- 75Ω F-type connector input RF signal
1-
RS-232- DB9 Serial Monitoring Interface (Bit rate: 9600bps, Data bits: 8, Parity: None, Stop bits: 1)
2-
Optical Input-Class 3B, SC/APC or FC/APC connector
3-
Power Jack- Supplies power to the equipment
4-
RF INPUT
Fuse- A 220V 1.5A fuse to protect the equipment against short circuits and power surges
5-
RF Test Point-75Ω F-type connector -20dB input RF signal test point
6-
7- GND-Case ground
RX-1
OPTCAL IN
RX-2
RF-TP
RF-TP
RF-OUT
-20dB
-20dB
1
1
POWER
RF
PD
2
3
3
OPTCAL IN
RX-3
OPTCAL IN
RF-OUT
RF-TP
RF-OUT
-20dB
MADE IN USA
5
RX#1 RX#2 RX#3 RX#4
^ OK
OFF
OK
ALM
OPTICAL RECEIVER
RX-4
OPTCAL IN
RF-TP
RF-OUT
-20dB
6
ncm@ncmsupplies.com
U
R
F
D
6
2
RS-232
MONITORING
INTERFACE
5
NCM Supplies Inc.
8125 NW 64th Street, Miami, Florida 33166
2101 N.W. 79 Ave. Miami, Florida 33122
Phone: 305-640-0461 Fax: 305-639-2684
|
www.ncmsupplies.com
4
OFF
ON
POWER ON
KEY
4
110-220 Vac/ 50-60 Hz
7
2
Advertisement
