Medline 9P-047020 User Manual

Alternating Pressure Relief System
Model No.:9P-047 Series
1. Introduction
This manual should be used for initial set up of the system and for reference purposes.
1.1 General Information
The system is a high quality and affordable mattress system suitable for treatment and
prevention of pressure ulcers.
The system has been tested and successfully approved to the following standards:
EN 60601-1
EN 60601-1-2
EN 55011 Class B
EN 61000-3-2 Class A
EN 61000-3-3
IEC 61000-4-2
IEC 61000-4-3
IEC 61000-4-4
IEC 61000-4-5
IEC 61000-4-6
IEC 61000-4-8
IEC 61000-4-11
FOR US AND CANADA ONLY
Le produit à été testé avec des équipements médicaux et respecte les normes UL
60601-1 & CAN/CSA C22.2 No.601.1. prévenant les choc électrique, le feu et les risques
de blessures physiques.
1.2 Intended Use
This product is intended to help and reduce the incidence of pressure ulcers while
optimizing patient comfort. It also provides following purposes:
Individual home care setting and long term care of whom suffering from pressure ulcer
Pain management as prescribed by a physician
NOTE: Equipment not suitable for use in the presence of a flammable anesthetic
mixture with air or with oxygen or nitrous oxide.
NOTE : L'équipement ne peut être utilisé s'il y a risque de mélange d'un anesthésique
inflammable avec l'air ou l'oxygène ou oxyde nitreux.
User's Manual
Please read the manual before use.

IMPORTANT SAFEGUARDS

READ ALL INSTRUCTIONS BEFORE USING
DANGER - To reduce the risk of electrocution:
1. Always unplug this product immediately after using.
2. Do not use while bathing.
3. Do not place or store product where it can fall or be pulled into a tub or sink.
4. Do not place in or drop into water or other liquid.
5. Do not reach for a product that has fallen into water. Unplug immediately.
WARNING - To reduce the risk of burns, electrocution, fire, or injury to persons:
1. This product should never be left unattended when plugged in.
2. Close supervision is necessary when this product is used by, on, or near children or invalids.
3. Use this product only for its intended use as described in this manual. Do not use
attachments not
recommended by the manufacturer.
4. Never operate this product if it has a damaged cord or plug, if it is not working properly, if it
has been dropped or damaged, or dropped into water. Return the product to a service center
for examination and repair.
5. Keep the cord away from heated surfaces.
6. Never block the air openings of this product or place it on a soft surface, such as a bed or
couch, where their openings may be blocked. Keep the air opening free of lint, hair, and
other similar particles.
7. Never drop or insert any object into any opening or hose.
NOTE, CAUTION AND WARNING STATEMENTS:
NOTE: Indicate some tips.
CAUTION - Indicate correct operating or maintenance procedures in order to prevent damage
to or destruction of the equipment or other property.
WARNING - Calls attention to a potential danger that requires correct procedures or practices in
order to prevent personal injury.
SYMBOLS
"BF"symbol, indicate this product is according to the degree of protecting against
electric shock for type BF equipment.
Attention, should read the instructions
Class II

2. Product Description

Unpack the box to check for any damage which may have occurred during shipment. If there
are damages, please contact your dealer immediately.
2.1 Pump Unit
Front
1. Power Switch
2. Front Panel
1
2
Rear
3. Air Hose Port
4. Hanger
4
5. Power Cord
3
5
2.2 Front panel
1. Comfort Adjustment Knob
1
2
Comfort adjustment knob controls the air pressure output.
When turning clockwise, the output pressure will be
increased.
counter-clockwise, the output air pressure will be
decreased. ( only available on # MSCAOPUMPADJ )
2. Main Power Switch
2. Main Power Switch
To turn on/off the pump unit with illuminated green
On the other hand, when turning