Advertisement
SIT-STAND DESK SYSTEM ONE
OPERATION MANUAL
SAFETY AND WARNINGS
Inappropriate use of this product may cause property or bodily injury.
Check surroundings on all sides before using the desk. Do not place any objects taller than 620 mm
(2 level columns) under the desk or frame.
Ensure the length of power cords are accounted for when operating the desk. Monitors, computers,
speakers, anything with a cord that is not long enough for the desk's range of motion could be pulled
down or have its wires broken. Check that no cables can get jammed.
Desks should not be used in environments with high humidity or dampness.
If you need to move the desk, DO NOT lift it only by holding the desktop. Lifting this way can stress
the fasteners connecting the frame to the desktop.
Please provide this operation manual to any users, installers, or support personnel operating the
product.
USAGE
This sit-stand desk has 1 electric lifting
column.
The desk height is adjustable so the
desktop can be fixed for most suitable
user's position. These desks are
designed only for ergonomic sit-stand
position.
Do not move around, crawl or lie under
the desk frame.
Do not sit or stand on the desk frame or
desktop.
Any other use is at user's risk.
IMPORTANT
80
Lifting capacity up to 80 kg.
Do not exceed this given load.
KG
1
! Please keep in mind that time for continuous desk movement
upwards or downwards is 1 minute.
MIN
9
After 1 minute of unstopped operation there has to be a resting
period of 9 minutes.
MIN
33
Travel speed up to 33 mm/s.
MM/S
www.narbutas.com
SETUP AND
INSTALLATION
Choose a placement for the desk that
is a safe distance from window frames,
radiators, furniture etc.
Once the desk has been assembled,
adjust the feet so that the desk is level
and does not shift its position.
After this, connect the desk to the outlet
and the desk is ready for use. For the
first start of desk please press and
hold "down" button for control box
activation.
2 level column:
650-1130 mm
TROUBLESHOOTING
• If there is no response when trying
to raise or lower the desk you have to
make reset of control box:
Press "down" and "up" buttons at the
same time for about 5 seconds, you
will hear short "beep" signal. Now
press "down" button, the desk will
slowly move down till it stops, you will
hear short "beep" signals. The desk
adjustment was made, now it should
function properly.
• If the desk does not go up:
Press the "down" button and lower the
desk till there is 100 mm gap to lowest
position. Press "down" and "up" buttons
at the same time for about 5 seconds,
you will hear short "beep" signal. Now
press "down" button, the desk will
slowly move down till it stops, you will
hear short "beep" signals. The desk
adjustment was made, now it should
function properly.
If these tips were not helpful please
contact your seller.
RESET
Advertisement
