In 2 Care Mosquito Trap Installation Manual

Contents
Refill package
Assembly
Fill the pot with 3.5 - 4.5 liters
(±1 gallon) of clean tap water.
For placement details see other side
of this sheet.
Slide the loop at the ending of the gauze over
the pin as shown.
Try not to touch the gauze extensively to avoid
removal of the active powders.
Put the gauze-carrying floater inside the trap
by gently placing it over the central tube flat
onto the water.
Prevent the gauze from getting wet as water
will degrade the powder.
Note: The In2Care Mosquito Trap does not immediately kill adult mosquitoes. The contents of the trap therefore may
not contain high numbers of dead mosquitoes. However, the trap kills the mosquito larvae that emerge from the eggs
that are laid inside the trap, prior to larvae transforming into adult mosquitoes. This means that small living larvae
may be encountered in the trap. The exiting adult female mosquito itself is contaminated, so that she can carry
powder to other breeding sites (in the vicinity of the trap). She will be killed by the powder after a few days.
Mosquito Trap
Pot Lid
Shake the refill package and open it by
tearing at the notches. Gently take out
the powder-coated piece of gauze.
Wrap the gauze around the floater
and slide the other gauze loop on the
last pin as shown. Work your way
around moving the gauze down at
each pin.
2
Place the lid on the central tube, push it down
and turn it clockwise.
Floater Time indicator cap
Empty the remaining contents (powder
and odor tablets) of the refill package
into the water of the trap. Avoiding the
gauze from getting wet.
Push the gauze down the pins until it
will go no further (where the bottom of
the pin hits the circular rib). The rib
will prevent the gauze from sliding too
far.
1
Installation
Turn the time indicator to the
number of the current month as a
service reminder.