Connecting Your Adapter - LeCroy WaveStation 2052 Operator's Manual

 GPIB controls can interface with compatible LeCroy oscilloscopes
and, if desired, a GPIB address may be used.
Note: The GPIB interface specifically supports Device (and not
Controller) mode.

Connecting Your Adapter

First, make sure you've set your WaveStation to receive the USB-GPIB
connection. This is described in Controlling WaveStation with USB-GPIB
and/or USBTMC (on page 76) and in the Main Utility Operations (on
page 62) topic. The default address for the adapter is 13.
Now, use the following steps to attach your adapter and know what the
LED indicator lights mean.
1. Attach the USB side of the connector to the interface on the
LeCroy compatible oscilloscope. Connect the GPIB side of the
connector to your Laptop or Desktop computer.
2. Verify the GPIB address on the oscilloscope. When making the
USB-GPIB setting on your This address number is set when
configuring your WaveStation for the USB-GPIB connection.
Ensure the address is correct. The default address for the adapter
is 13.
Note: The GPIB address is then saved in the GPIB card on your
oscilloscope.
WSta-OM-E RevA
Operator's Manual
77