Table of Contents
Advertisement
Important Notice:
Please read this manual and all warnings including those provide by the battery manufacturer. This
manual is written to assist in the safe installation of the TruePower Plus Inverter. Installation must
comply to the applicable electrical codes and when installed on a boat the American Boat and Yacht
Council (ABYC) E-11 standards.
WARNING TO OWNER AND INSTALLER:
Read to avoid risk of injury or fire. INSTALL BY A CERTIFIED ELECTRICAL TECHNICIAN. INSTALLATION
MUST COMPLY WITHTHE FOLLOWING GUIDELINES:
To prevent risk of fire damage: All DC stud and cable hardware must be securely tightened.
Fasten DC input cables with proper strain relief within 6" of inverter.
Attaching battery cables to DC studs: Use two appropriately sized wrenches for each connection
7/16" or 1/2" wrench required (model specific). Tighten until lock washers compress.
Installing DC safety fuse: Install fuse in positive (+) cable within 7" of battery. See page 17 for
recommended fuse sizes.
DC Input Cables: Cable size must be specified per length and DC input amperage of installed
TruePower Plus Inverter. See page 17.
WARNING: Risk of Fire. Do not replace any fuse with a rating higher than recommended by the
manufacturer. Ensure that the dedicated electrical system fuse can supply this product without causing
the fuse to open. On no account should fuses be bypassed as this can cause serious damage, fire or
risk of death.
WARNING: This device is not ignition protected, risk of fire or explosion.
This equipment contains components that could produce arcs or sparks. To reduce the risk of fire
or explosion, do not install this equipment in compartments containing batteries, flammable
materials or fumes, or in a location containing gasoline-powered machinery, or joints, fittings,
or other connections between components of the fuel system.
WARNING: Low voltage - electrical burn and spark hazard. Disconnect battery power before servicing.
WARNING: ELECTRICAL SHOCK HAZARD
Do not disassemble the TruePower Plus Inverter. It does not contain serviceable parts and attempting
to service the unit could result in an electrical shock or burn.
CAUTION: Polarity and wire color must be observed when making the installation connection
to a 12 volt battery.
Red DC input bar = + (positive) red cable battery connection only.
Black DC input bar = - (negative) black cable battery connection only.
NOTE: REVERSE POLARITY CONNECTION WILL DAMAGE UNIT AND VOID WARRANTY.
Introduction...
Installation...
Operation...
Maintenance...
Warranty...
Contents
UNPACKING AND INSPECTION
Thoroughly inspect your TruePower Plus unit. The package should contain the following:
1) TruePower Plus unit
2) Parts package including:
a. + (red) and - (black) DC terminal cover.
b. Remote package including panel, cable and mounting screws
c. Owners/installation manual
TABLE OF CONTENTS
1-2
3-4
5-10
11-17
18
19
20
21
22
Hide quick links:
Advertisement
Table of Contents
