EazzyDV IB-185W User Manual page 19

5.2.1 WiFi Mode Trouble Shooting Strategy
If you cannot connect bulb camera to a WiFi router even when password and everything else is correct.
The problem may be caused from the WiFi router setting. Please read below instructions, There are some
key points you must be aware of:
1. Router's DHCP service must be enabled. Bulb camera depends on it to get IP
address.
2. Router's SSID must have no spaces in between, that means formats like "my ssid"
is not acceptable; only "myssid" acceptable
3. For the Router's wireless channel, we would suggest using no. "13" (some old
router without channel 13, then select channel 11)
4. For the Router's security method, we would suggest using "WPA2-PSK" (AUTO is
not recommended, WEP is not working)
5. For the Router's encryption method, we would suggest using "AES" (AUTO is not
recommended)
5.3
Switching from Factory Mode to Wifi Mode by PC/Notebook
If your mobile phone is not available, you can also use pc software to change WiFi setting. The steps are :
5.3.1 Use PC/Notebook wifi, connect to bulb camera. Each bulb camera has unique device ID
5.3.2 Input password "88888888"
5.3.3 Run PC software "bulbcam.exe"
5.3.4 Under LAN section, a bulb camera ID shown
5.3.5 Right click mouse button, select "Device settings"
__________________________________________________________________________________________
Eazzy Digital Video Technology Limited 19 / 36 www.eazzydv.com