Operation; Setting The Beep; Loading A Cassette Tape; Recording A Phone Conversation - Radio Shack TCR-200 Owner's Manual

43-473.fm Page 8 Friday, August 13, 1999 9:21 AM

OPERATION

SETTING THE BEEP

You can set the telephone cassette re-
corder to beep every 15 seconds while
recording.
Note: You might be legally required to
set to
BEEP TONE ON
so all parties know the conversation is
being recorded. Check the laws in your
area.
1. Remove the battery compartment
cover and remove the batteries, if
installed.
2. Set
BEEP TONE
phone cassette recorder beeps ev-
ery 15 seconds while recording.
3. Replace the batteries and the cover.
LOADING A CASSETTE
TAPE
Follow these steps to install a cassette
tape (not supplied) in the recorder.
1. Turn the cassette's hub with a pencil
to take up any tape slack.
8
when recording,
to . The tele-
ON
2. Press
STOP/EJECT
sette compartment door. Put the
cassette in the compartment with
the cassette's open edge facing you
and the full reel on the left.
3. Close the door.
Notes:
• You can buy cassettes of varying
lengths at your local RadioShack
store.
• Replace the tape at least once a
year, or more often if it is used
heavily.
RECORDING A PHONE
CONVERSATION
You can record both sides of a conver-
sation on any phone connected to the
same phone line as the recorder.
1. Set , the sensitivity level,
REC MODE
, and
SPEED MONITOR
settings. (See "Setting the Record
Mode" on Page 9, "Setting the Sen-
sitivity Level" on Page 9, "Setting
the Recording Speed" on Page 10,
and "Listening While You Record"
on Page 10.)
to open the cas-
to the desired