OpeMed OT200 User Manual

peMed
OT200 User Quick Guide
QUICK GUIDE – OPEMED OT200 CEILING HOIST
Before use
• Do NOT attempt to lift a higher load than the SWL (safe
• Check that status of the batteries on the cassette s display
working load) of the hoist. See side of hoist (normally
• Is the emergency stop de-activated? (Red cord)
200kg).
• Check whether the used sling fits the purpose and the transfer
• Only trained personnel should use the OT200 Ceiling Hoist
• Check the condition of the sling and the clips and whether the whalebones are placed
• Read the User Manual before use.
• Carefully place the sling
• Do NOT pull the hoist by the handcontrol.
• Is the user able and comfortable to be lifted?
• Do NOT wrap the handcontrol chord around the spreader bar and
• The cassette will automatically activate when any button on the hand-held control is pushed
lower the spreader bar, this will snap the chord.
• When using a standard sling, always place the arms of the user inside the sling on the user's lap.
• Always return the hoist to the Charging Station when not in use.
• Only use approved loop slings (or clip slings if the cradle is fitted). • When using a toilet sling always make sure the arms of the user are outside the sling so that the
upper slips with clips pass beneath the arms!
• Always work in a neat and clean environment
HANDCONTROL
Using the OT200
• The handcontrol will operate the hoist up and down (also
• Place the sling behind the back of the user down to the seat. Let the user sit slightly forward during
this handling. Make sure the sling is placed with the washing instructions facing to the outside
left/right if you have a 4 function motor or tilting spreader if
• Pull the leg slips slightly forward; this way the user already sits 'inside' the sling
fitted).
• Lift one of the user's legs and bring one leg slip of the sling to the inside of the leg. Use the same
o For horizontal drive the white and blue arrow match
method to apply the other leg slip
2.1 Charging and Life-Span of the Batteries
the white and blue arrow on the hoist.
• If necessary, pull the head side of the sling up to the correct height. The sling will now fit around the
In order to maximize the life span of the batteries, it is advised to put the cassette into the
user like a 'tank chair'
charging station when the cassette is not being used, but the unique Gravity Powered Charging
on the OT200 will maximise the battery life of the hoist.
CHARGING
• When using a toilet sling apply the circular belt (leg-side) like a belt around the waist of the user.
Always charge the battery when the yellow battery indicator is
Put the arms of the user through loops on the head-side of the sling
blinking.
• Raise and Lower the user by means of the hand-held control
• Whenever not in use the Motor should
Charge the batteries according to the following procedure:
- Make sure the charger is connected to the electricity supply.
be stored at the Charging Station.
• Whilst moving, walk with the lift. Stay as close to the user as possible
- The red/amber/green indicator on the charger will light up depending
on the state of the battery.
• Approach the bed, chair or toilet and then determine the required height for bringing the user to the
- Place the cassette below the charging strips (box on side of rail with
final position
two metal springs) • If the hoist needs charging the orange
- After several seconds charging will start automatically and the yellow indicator on the cassette will light
light will illuminate when the hoist is under the Charging Station.
when charging and go-out when fully charged. The light on the charger will either show red/amber/green
depending on the state of the batteries.
Hoists Ceiling Hoists
- Allow for a charging time of 6-8 hours.
OpeMed (Europe) Ltd
Clockhouse, Farnham
2.2 Capacity
The number of lifting cycles that can be done with a fully charged battery depends on the time per lifting
Surrey. GU9 7UD
cycle, the lifted weight and the age and condition of the battery. The OpeMed Gravity Powered Charging
will maximise the lifecycle of the battery.
•
Step-by-step lifting instructions
•
Maintenance of the OT200/ OT400; to be carried out by the car
Next to this manual the following documentation is available on th
•
Technical manual. The technical manual is developed for the tec
-
-
- parts lists with order numbers
•
Installation manual. This manual can be used during the installa
-
- i
- installation of carousel
- part lists with order numbers of all components of the rail syst
•
Quick Reference. The Quick Reference guide deals with the mai
to the OT200.
1.2
1.3
The delivered package must contain:
•
Cassette
•
Hand-held control
•
Charger
•
Charging station
Remove the packaging from the OT200 and check the contents of
4
Changing Tables Showering Tables
www.opemed.net
www.opemed.net
OT200 Ceiling Hoist
Preparations and Guidance
maintenance procedures
Before and During Use
repair procedures
installation of rail and supports
nstallation of a gate (transition from fixed to mobile rails)
Symbols
Attention
Attention, High Voltage
With this, the OT200 meets the European Standard, IS
GQ-quality mark T-02, cluster UTT.
Contents of the Package
• • • User Manual
Shower Chairs
•
Technical manual. The te
-
maintenance procedure
-
repair procedures
- parts lists with order nu
•
Installation manual. This
-
installation of rail and s
- i
nstallation of a gate (tr
- installation of carousel
- part lists with order num
•
Quick Reference. The Qu
to the OT200.
1.2 Symbols
Attention
Attention, High V
Read the man
With this, the OT
GQ-quality mark
The producer
1.3 Contents of the Pa
The delivered package mus
•
Cassette
•
Hand-held control
•
Charger
•
Charging station
• Spreader Bar
Remove the packaging from
•
User manual
•
Quick reference
4
• • • User Manual
Bathing
T: +44 (0)1252 758858
E: info@opemed.net
Guide: OT200QG
e: