AirSep Focus Service Manual page 13

3) Connecting Focus with the Battery, as shown:
Before using the battery, check that it has a sufficient charge.
The battery is equipped with a gauge (Figure 9) to indicate the level of battery charge (25-
100%). To check the level of charge of the battery, press the button on the battery's keypad.
The battery gauge/indicator(s) LEDs to the left of the button illuminate to indicate the level of
battery charge (25-100%). Connect the switch end of the battery cord into the Focus unit's
power inlet only, as shown in Figures 5 and 6.Connect the other end into the battery. Do not
force the cords, as they can be properly inserted only one way.
Refer to the instructions on charging the battery in the Battery Charging section.
11
4) Connecting Focus with the Optional AirBelt
Check that the AirBelt is sufficiently charged. It requires approximately 3 ½ hours to completely
charge. AirBelt (Figure 7) is equipped with a fuel gauge to indicate the level of battery charge
(25-100%). To check the level of charge, press the button on the AirBelt keypad. The battery
gauge/indicator(s) illuminate to indicate the level of battery charge (25-100%). Connect the
interface cable (Figure 8) into the AirBelt, then plug the other end of the interface cable into the
Focus, as shown in Figure 9. For proper orientation of the connector, see Connecting to the
Focus Power Inlet section. Turn the Focus unit on by pressing the power switch to the on
position (l).
Refer to the instructions on charging the battery in the Battery Charging section.
Figure: 7
AirBelt
battery
MN171-1 Rev. B
Figure: 5
Figure
AirBelt
battery
charge level
(25-100%
Figure: 8
AirBelt to
Focus cord
Belt / Shoulder Figure: 6
Strap clip
™
Figure 11
Battery
Focus units Power Inlet
Battery Gauge
F
i
g
u
r
e
4
AirBelt to
Figure: 9 Focus
AirBelt connection
battery
with Focus
F
i
g
F
i
g
u
r
e
4
F
i
g
u
r
e
4