Advertisement
WIRELESS KEY
TRANSMITTER
Installation Instructions For Colored
Adhesive Labels And Buttons
The No. 5804 is supplied with colored buttons (Red
and Blue) and colored adhesive identification labels
(Blue, Red, Gray and Green).
specified command function and symbol printed on it,
as well as an adhesive back for easy pasting.
To paste a label on a button, slowly peel off a selected
function and paste on the button of the transmitter.
If you decide to re-program a button, the label can be
easily removed or a new label pasted over the existing
one.
Additional colored buttons are also provided (red and
blue) which can be used with or without the labels.
The buttons can only be inserted in the areas provided
for them (see Figure 2).
To insert the colored buttons, do the following:
1.
Holding the transmitter with the buttons face
down, remove the case back by using the blade of
a small screwdriver to pry open (see Figure 1).
2.
Carefully remove the PC board by its rubber
casing, making sure the board does not come out
of the casing. Do not to bend the exposed battery
tabs on the PC board.
3.
Replace the desired buttons, either red or blue, in
each button's designated opening (see Figure 2).
4.
When finished, replace the PC board, making
sure the button tabs on the board face the four
buttons, and snap case front and back together.
N7674-1 7/95
No. 5804
Each label has a
Battery Tabs Shown
Figure 1
Figure 2
REFER TO THE INSTALLATION INSTRUCTIONS
FOR THE RECEIVER/CONTROL WITH WHICH THIS
DEVICE IS USED FOR WARRANTY INFORMATION,
AND FOR DETAILS REGARDING THE LIMITATIONS
OF THE ENTIRE ALARM SYSTEM.
ALARM DEVICE MANUFACTURING COMPANY
A DIVISION OF PITTWAY CORPORATION
165 Eileen Way, Syosset, New York 11791
Copyright © 1995 Pittway Corporation
Blue
Red
Advertisement
