Advertisement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:Ê
(1) This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
SPECIFICATIONS
Unit Dimensions:
2.25Ó (57mm) x 1.5Ó (38mm) x 0.5Ó (12.7mm)
BATTERY ACCESS
+ POS. end
must face down
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL
WITH WHICH THIS DEVICE IS USED FOR WARRANTY INFORMATION, AND FOR
DETAILS REGARDING THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
FCC STATEMENT
FCC ID: CFS8DL5804
+ POS. end
must face down
ALARM DEVICE MANUFACTURING COMPANY
A DIVISION OF PITTWAY CORPORATION
165 Eileen Way, Syosset, New York 11791
Copyright © 1995 Pittway Corporation
Battery:
Maxell CR2025 or Duracell DL2025.
Battery Access:
Remove case back by using the blade of a small
screwdriver to pry open. Place batteries in case
back locations (see diagram).
+ POS END MUST FACE DOWN.
To close, snap case front and back together.
Important Note: Do not remove Printed Circuit Board.
N7674 7/95
Advertisement
