Connecting To The App And Wi-Fi Network; Configuring The Thermostat For Your Hvac System - iDevices HVAC Installation Manual

based on the information you gathered in
the chart on pages 11-12, photos you took
earlier and wiring configuration you noted
for step 15.
17. To prevent electrical shorts and damage to
your iDevices Thermostat or home, ensure
®
all of the wire connections are secure
and there are no bare wires in contact with
another. Insulate bare wires with electrical
tape as necessary. Push any excess wire back
into the wall cavity.
18. Attach your iDevices
mounting plate.
19. Turn your power on at the breaker box or
switch that controls your heating/cooling
system.
20. Your iDevices Thermostat will automatically
®
turn on and display the "Connecting
Thermostat to Network" screen.
Note: The Thermostat will stay in the
connection mode for 30 minutes before
timing out. You can manually enter this mode
from the Settings > Setup > Connect menu.
Connecting To The App And Wi-Fi
1. Download and launch the free iDevices
Connected app on your mobile device.
Thermostat to the
®
Network
®
®
2. From the iDevices
Thermostat by tapping on the menu bar in
the upper right-hand corner.
3. Follow the instructions in the app to
complete the connection process.
Configuring The Thermostat For
Your HVAC System
1. Refer to Thermostat Settings for your system
configuration, starting on page 8.
2. Press the
iDevices
3. Use the
and press the
4. Use the
and press the
5. Using the
button to select, set the Stage and Type for
your system configuration (A through D).
6. If you have a heat pump, set O/B Type to
what you recorded earlier.
7. Your iDevices
Configuring the HUM Relay
The Terminal labeled "HUM" serves as
multipurpose relay to allow for Humidification,
14
Connected app, add the
®
button on your
Thermostat.
®
buttons to scroll to 'Setup'
button to select.
buttons to scroll to 'HVAC TYPE'
button to select.
buttons to scroll and the
Thermostat is now configured.
®
15