Download Print this page

Yamaha NS-150 Service Manual page 4

Hide thumbs Also See for NS-150:

Advertisement

NS-150
ATTACHING THE STAND
Screw (6 mm) x 4
Stand x 4
When positioning the speakers, be sure to use the stand to
increase stability.
Use the 8 specified holes located on the base of the
speaker.
Procedure:
1. Put the 6 mm screw through the larger hole on the
stand, and to the speaker at one of the outside holes on
the base of the speaker. At this time, attach the stand to
the speaker so that it can still be moved slightly.
2. Put the 4 mm wood screw through the smaller hole on
the stand, and screw it into the inside hole on the base
of the speaker.
3. When both screws have been attached, tighten both of
the screws so that the stand is firmly in place.
Be sure to check that the stand is firmly attached.
4. Attach the pads to the bottom of the end portion of the
stand.
5. Attach the other stands in the same manner and confirm
that all 4 stands have been firmly attached.
6. Place the speaker in the desired location.
Note
If force is applied to the side of the speaker, it may fall
and damage the speaker or cause personal injury.
Please be careful.
Wood screw
(4 mm) x 4
Pad x 4
ATTACHING THE SPIKE
Spike x 4
When setting up the speakers on a thick carpet, use the
spikes instead of the stand. With 4 points set in place to
achieve increased stability and improvements in sound
quality.
Procedure:
1. Set the nut close to the tip of the spike and screw them
into the bottom of the speaker at each of the four
specified holes.
2. Place the speaker in the desired location in an upright
position and adjust the length of the spike to match the
depth of the carpet.
3. When adjustment is complete, twist the nut up to the
base of the speaker firmly.
Notes
• The tips of the spikes may scratch or otherwise
damage the flooring. Please be careful when
positioning the speakers.
• If force is applied to the side of the speaker, it may
fall and damage the speaker or cause personal
injury.
Please be careful.
• Either end of the spike may be inserted into the
holes on the speaker to accommodate different
types of conditions and installations.

Advertisement

loading