Table of Contents
Advertisement
Grip Adjustment
Pull back the pad
Attaching the Audio Unit
The audio unit (with handle) is not attached
to the camcorder unit when purchased.
Attach the audio unit according to the
following procedure.
Audio Unit
Screw
Shoe
Cable
16
Pad
Adjust the length of the belt
Clamp
Cable
Open the cover.
Attach the audio unit by sliding it all the
1
way into the shoe on the top of the
camcorder.
Take care not to slide in too much as it
will be impossible to tighten the screws.
At the point where A and B are aligned,
turn the screw on the audio unit
2
clockwise to fasten it fully and securely
to the camcorder.
.
To fully secure the audio unit, use a coin
or the like to fasten the screw
completely.
If the audio unit is not fully and securely
tightened, it will be loose and may drop
off from the camcorder during use.
Connect the audio unit cable to the
3
microphone connector of the
camcorder.
The clamp on the audio unit is for fixing
the microphone cable and cannot be
used to fix the audio unit cable.
Attach the pad
A
B
Advertisement
Table of Contents
