1. Manuals
  2. Brands
  3. CloudGate Manuals
  4. Gateway
  5. Marwis
  6. User manual

CloudGate Marwis User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
CloudGate „Marwis"
Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Marwis and is the answer not in the manual?

Questions and answers

Related Manuals for CloudGate Marwis

Summary of Contents for CloudGate Marwis

  • Page 1 CloudGate „Marwis“ Manual...
  • Page 2 Operating manual CloudGate V 1.0 / 01.02.2017 Version 1.00 01.02.2017 P. Rau / Informatik Werkstatt GmbH...

  • Page 3: Table Of Contents

    Operating manual CloudGate V 1.0 / 01.02.2017 Contents Connecting the Marwis/UMB ................ 4 Power Supply ..................... 4 Status LEDs ....................4 Hints for the operation ................5 Configuration User Interface ................ 5 Configuration files ..................7 /myconfig/marwis.ini ................7 /myconfig/sensor_config.ini ..............8 Log file ......................

  • Page 4: Connecting The Marwis/Umb

    Operating manual CloudGate V 1.0 / 01.02.2017 Connecting the Marwis/UMB The Marwis device / UMB bus is connected via the RS485 interface on the CloudGate device (green connector on the left side) using the pins: TX+ = A (green) TX- = B (yellow)

  • Page 5: Hints For The Operation

    CloudGate antennae since they may interfere with the GPS and GPRS signals. If the CloudGate does not receive any valid GPS data during 60 s it will interrupt the data transmission to ViewMondo and data will be lost. ...
  • Page 6 A form with basic settings for the Marwis app is shown: Change the values to your needs, and click “save”. This will save the values to the config file (see below) and re-start the Marwis app (not re-boot the device!), so that the changed parameters will take effect.

  • Page 7: Configuration Files

    Operating manual CloudGate V 1.0 / 01.02.2017 Configuration files There are 2 configration files, located in the „\myconfig“ folder on the CloudGate device. File security for these files permits the “admin” user to read/write these files, so they can be edited by logging on via SSH and using a text editor (vi).

  • Page 8: Myconfig/Sensor_Config.ini

    “hints for the operation” Attention! Doing an update with the IOS MARWIS app is only possible at the moment as long as there is no connection to the CloudGate. Before starting an update therefore please unplug the RS485 connection on the CloudGate housing and only re-plug it when the update has finished.

Table of Contents