Computer Configuration; Adsl Modem Work Model Configuration - Riger DB108-WL User Manual

Before the installation starts, please confirm information below or consult ADSL service provider. Table 2.1
shows all the information needed to configure according to different protocols.
Table 2.1
VIRTUAL DIAL
PROTOCOL
PPPoE
VPI
VCI
LLC/VCMUX
NECESSARY
INFORMATION
USER NAME
PASSWORD
INSTALLATION
3 3
GUIDE

2.3.2 COMPUTER CONFIGURATION

The default factory-set IP Address for the ADSL MODEM is 192.168.1.1. The Subnet Mask is
255.255.255.0 Users can configure ADSL MODEM through an Internet browser. ADSL MODEM can be used as
gateway and DNS server; users need to set the computer's TCP/IP protocol as follow:
1 Set the computer at same Internet segment with ADSL MODEM enter ADSL MODEM configuration
interface through a browser.
2 Set the computer's gateway the same as the ADSL Modem's IP address.
3 Set computer's DNS server the same as the ADSL Modem's IP address or that of an effective DNS server.
4. Wireless configurations are detail discussed in 2.3.5.
2.3.3 ADSL MODEM CONFIGUTATION
Open the browser; input http://192.168.1.1 at the address column. Press "Enter" key then the entry dialog box
will show up as Figure 2.1, Input username: admin, and password: dareadsl (Note that this is capital sensitive),
then the language selection page will appear. Please choose the "English" and click "OK". The login pages are
shown as Figure 2.2.

2.3.4 ADSL MODEM WORK MODEL CONFIGURATION

1 According to the different protocols, Users need to set ADSL Modem as listed below:
MODE
PPPoA
VPI
VCI
LLC/VCMUX
USER NAME
PASSWORD
3 3
(a)
Figure 2.2
- 5 -
DB108-WL wireless ADSL MODEM manual
PRIVATE LINE MODE
1483 BRIDGE 1483
CONNECT ROUTING
VPI VPI
VCI VCI
LLC/VCMUX LLC/VCMUX
IP ADDRESS/
MASK
GATEWAY
3 1 3 2
(b)
1577 PRIVATE
LINE
LINE VPI
VCI
LLC/VCMUX
IP ADDRESS/
MASK
GATEWAY
3 2