ALDI AU4-PU-4A User Manual page 11

Heart Rate Monitor
When the chest strap is being worn, the current heart rate in the middle display
segment is shown. Otherwise, "—" is shown. The heart symbol flashes if the heart
rate is being received by the chest strap. If no signal is received anymore, the heart
symbol stops flashing and the last heart rate remains in the display.
Caution: If the watch should not receive any heart rate in Basic mode within the first
two minutes, the black bars "—" will stop flashing. In this case, please check the
placement of your chest strap and moisten the contact surfaces. Then, please press
the "MODE" key, in order to restart the search for the chest strap signal.
Caution: All of the sub-functions described below only work with the chest strap
attached.
5.3.1 Stopwatch
The stopwatch in the heart rate mode has the function of a training timer.
In heart rate mode, press the "SEL" key until the stopwatch ("STOPP" / "STW") is
displayed in the top display segment:
Training time
When you start training, you can keep track of the training time, in order to effectively
know how you were active.
•
Press "SET" key – start timer
•
Press "SET" key – stop timer
•
Keep "SET" key pressed in order to reset the training time to zero
The training time shows the total time, from the moment when you activate the timer
until the point at which you stop the timer. Even if you switch from heart rate mode to
one of the other modes, the time continues to run in the background.
Caution:
Please note that training data, such as highest, lowest and average heart rate, as
well as the training time within, above and below the set training zone can only be
saved, if you have activated the timer (stopwatch) in heart rate mode.
The values for calories and fat are calculated automatically, as soon as the chest
strap attached and a heart rate is received.
AFTER SALES SUPPORT

service@produktservice.info / www.produktservice.info
11
Main functional modes

1-800-493-9137