Operation - RIDGID R6300 Operator's Manual

OPERATION

WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear safety goggles or safety glasses with
side shields when operating tools. Failure to do
so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal
injury.
APPLICATIONS
You may use this tool for the purpose listed below:
n Driving nuts and bolts using an impact socket
SWITCH TRIGGER
See Figure 2.
To turn the impact wrench ON, depress the switch trigger.
To turn it OFF, release the switch trigger.
REVERSIBLE
See Figure 2.
The impact wrench has a rocker-type switch trigger for
operating the wrench in forward or reverse. To operate the
wrench in a forward direction, depress the lower half of the
switch. To operate the wrench in reverse, depress the upper
half of the switch.
To stop the wrench, release the switch trigger and allow the
motor to come to a complete stop.
TWO-SPEED SWITCH
See Figure 3.
The impact wrench has a two-speed switch designed for
operating at LO (1) or HI (2) speeds. A slide switch is lo-
cated on top of the wrench to select either LO (1) or HI (2)
speed. When using the wrench in the LO (1) speed range,
the IPM (Impacts Per Minute) will decrease. When using the
wrench in the HI (2) speed range, IPM will increase. Use the
LO (1) speed for slow applications and HI (2) speed for fast
applications.
LO (1)
10
REVERSE
FORWARD
SWITCH
TRIGGER
TWO-SPEED
SWITCH
HI (2)
Fig. 2
Fig. 3