Table of Contents
Advertisement
Advertisement
Table of Contents
Troubleshooting
Summary of Contents for Transfer Flow TRAX 3
- Page 1 ™ Owner’s Manual Fuel Management System for Transfer Flow Auxiliary Fuel Tanks...
-
Page 2: Table Of Contents
Maintenance and Troubleshooting ................6 ™ TRAX 3 Troubleshooting Table ................7 Important Safety Information ................... 8 Transfer Flow Replacement Parts ................9 Warranty ........................9 1444 Fortress Street, Chico, CA 95973 (800) 442-0056 • (530) 893-5209 Fax (530) 893-0204... -
Page 3: Trax 3 ™ Fuel Management System
Transfer Flow auxiliary fuel tank. The fuel level in the main tank and auxiliary tank will decrease at similar rates and the LCD will display the fuel level percentages or gallons in each tank and the operational status of the system. -
Page 4: Fuel Transfer Operation
Fuel Transfer Operation When the main and auxiliary fuel tanks are at or near full, the LCD displays “Full” for both tanks. When the main tank falls below 85%, the system automatically transfers fuel from the auxiliary to keep the main tank at 85% until both tanks are equal. -
Page 5: Computer Module Overview
Computer Module Overview Page 3... -
Page 6: Frequently Asked Questions
The TRAX 3™ module monitors the level of fuel in the main tank, and then sends that same information to the fuel gauge on the dash. - Page 7 The vehicle will now operate from the main tank only and the main tank gauge will read the fuel level in the main tank just as though the Transfer Flow system was never installed. Please call Technical Support at (800) 442-0056 x2 or (530) 893-5209 x2 if you ever have this issue.
-
Page 8: Maintenance And Troubleshooting
If the LCD displays, “CRITICAL FAILURE/DISCONNECT POWER” the user should deactivate the system by disconnecting the power to the computer module, located on the top or side of the auxiliary tank. Reference the “TRAX 3™ Computer Module Overview” diagram on Page 4; disconnect the three pin connector with the red and black wire that goes to the TFI wire harness. -
Page 9: Trax 3 ™ Troubleshooting Table
CHK FLTR kinked line, broken electrical staying on Technical Support connection, or excessive fuel sloshing Check for 12V Display not @ TRAX 3™ LCD, Blank Display not getting power turning on check fuse/call Technical Support Transfer Flow Technical Support: (800) 442-0056 x2 or (530) 893-5209 x2... -
Page 10: Important Safety Information
• Never overfill or “top-off” any fuel tank. Overfilling the fuel tank may cause damage to the emissions system, cause dangerous spills and possibly result in a fire. The Transfer Flow TRAX 3™ system may also shut down in the event of a “top off” condition. -
Page 11: Transfer Flow Replacement Parts
“off the shelf” parts and cannot be replaced with parts that appear to be similar. For example, the in-line fuel pump used with our TRAX 3™ system appears to be a normal fuel pump, but it is actually a high-quality solenoid pump with a critical forward and reverse check feature. -
Page 12: Fortress Street, Chico, Ca
1444 Fortress Street, Chico, CA 95973 (800) 442-0056 • (530) 893-5209 Fax (530) 893-0204 www.TransferFlow.com © Transfer Flow Printed in USA REV 4/19/2018...
Need help?
Do you have a question about the TRAX 3 and is the answer not in the manual?
Questions and answers