Analog Audio Input Connections - Parasound HINT 6 Owner's Manual

Analog Audio Input Connections

Always unplug your HINT 6's AC Mains power cord before making or changing any input, output or
trigger wire connections. Inserting or removing an input or output cable while the HINT 6 is turned
on can result in a blast of sound that could damage your loudspeakers. Make sure there is no
strain or tension on any cables that could cause them to pull loose.
Phono Input
The HINT 6 is equipped with a high-quality phono stage. If you wish to connect a turntable,
set the Load/Cartridge switch to MM (moving magnet) or MC (100 Ω or 47k Ω moving coil),
depending on your cartridge type. Select MM if you are not sure which type of cartridge you
have. If you use the MC setting with an MM cartridge the volume level will be very high and
distorted.
Note: Only a turntable can be connected to the Phono input.
Phono Load/Cartridge Switch
The Phono input has a three-position Load/Cartridge selector switch. Select the switch
position that matches your turntable cartridge type. We recommend that you contact the
cartridge manufacturer if you are unsure which setting to use. You can also try all three
settings and use the setting which sounds the best in your system and listening room.
.

MM is for moving magnet cartridges. It provides a 47 k ohm load and the appropriate
gain for all MM cartridges. This is the most common cartridge type.

MC 100 Ω is for most moving coil cartridges. It provides the higher gain required for even
very low output MC cartridges and a 100 ohm load that is ideal for most MC cartridges.

MC 47 k Ω provides the appropriate gain for MC cartridges with an alternative 47 k ohm
load. You can try both the 100 Ω and 47 k Ω settings to see which sounds best in your
system The MC 47 k Ω setting is also the load which Grado™ recommends for their MI
.
(moving iron) cartridges.
Note: If your turntable won't reach adequate volume, or if it plays too loud, you have
selected the incorrect cartridge type. Don't forget to connect the ground wire from your
turntable to the Phono GND (ground) terminal on the HINT 6.
7