SMC Networks ATV50 Service Manual page 6

14. When oil seal is ins
the oil sea al with the n
outside, an nd check th
installed fo or smoothn
oil seal.
15. Remove re esidues of
reinstallati on, grind w
has any da amage.
16. The ends o of rubber h
should be pushed as
so that the ere is enou
tightening the clamp
17. Rubber an nd plastic b
the origina al correct p
18. The bearin ng tool sho
removing a a ball bear
inner race or outer ra
bearing, us se equal fo
stalled, fill t he groove
name of th e manufac
he shaft on n which the
ness and fo or burrs tha
the old ga asket or sea
with a grind dstone if th
hoses (for fuel, vacuu
s far as the ey can go t
ugh room b below the e
s.
boots shou ld be prop
positions as s designed
ould be pre essed again
ring. Dama age may re
ace). In thi s case, the
orce on bo th races.
(Bo oth of thes se example
SMC MC ATV50
with greas se, install
cturer facin ng
e oil seal is s to be
at may dam mage the
alant befor re
he contact surface
um, or coo olant)
to their con nnections
enlarged en nds for
erly reinsta alled to
d.
nst two (in ner and ou
esult if the t tool is pres
e bearing s should be r
es can res sult in bear
0/100 Se Service M Manual
Chapte er 1 Gen
uter) bearin ng races w when
ssed again nst only one
replaced. T To avoid d
ring damag ge)
eral Inform mation
e race (eith her
amaging th he
- 5 - -