Syncing Two Bases - beautyrest SMARTMOTION BASE 3.0 Owner's Manual

syncing two bases

If simultaneous operation of two bases is desired, use the SmartSync™ Cord
STEP 1
Unplug base from power source.
STEP 2
Disconnect the power-down box cable from the splitter
cable. Make note where the cable was plugged in.
STEP 3
Connect the male end of the sync cord to each splitter
cable. Insert it into the same port that you disconnected
the power-down box from in Step 2
to connect the electronics of both bases together.
STEP 4
Connect each power-down box male connection to the
sync cord female connection (Refer to the illustration
below).
STEP 5
Plug base back into the power source.
STEP 6
Check to ensure all cords are securely attached. Both
remotes will now operate both bases simultaneously (If
the remotes become unpaired, see page).
15