Subscribe to Our Youtube Channel
Related Manuals for netvox ZB02C
Summary of Contents for netvox ZB02C
-
Page 1: User Manual
ZigBee - Wall Switch User Manual Battery-Powered Wall Switch (ON/OFF / Dimmer/Door Bell/ Panic Button/ Scene & Mode Selector) Model: ZB02C 20140103 FW V1.0 HW V5.0... - Page 2 1. Introduction Netvox ZB02C, a battery-powered wall switch, acts as an End Device in ZigBee network. It does not perform permit-join function as a coordinator or a router for other devices to join the network. It can be bound with the On/Off devices such as ZigBee enabled power plugs or power outlets.
-
Page 3: Product Appearance
2. Product Appearance Opening Indicator Button 1 Button 2 Button 3 Button 1 Button 2 Button 3 Binding Key Battery Holder 3. Specification Fully IEEE 802.15.4 compliant Utilizes 2.4GHz ISM band; up to 16 channels Power supply: 2 x AAA batteries. Operating consumption: ≤... -
Page 4: Installation Diagram
When ZB02C is in a ZigBee network → it will send out the device data, like IEEE address/Network address, and the indicator will flash 5 times. ZB02C will be activated for 2 minutes. When ZB02C was in a ZigBee network, but by any change it is offline → it will start to rejoin the ZigBee network. - Page 5 Step3. The indicator will flash 5 times after it is joined successfully. Otherwise, the indicator will not flash. ZB02C will try to join the network for 1 minute. Please try step1~3 again when it is failed to join the network. 5-3. Binding ZB02C can be bound with the On/Off device such as Netvox Z801RX.
- Page 6 5-5. Battery When the operating voltage is lower than 2.4V, the indicator will flash once. ZB02C will send a low-power report to the ZigBee network. 5-6. Restore to Factory Setting To restore it to factory setting, please follow the steps: Step1.
- Page 7 FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the ZB02C and is the answer not in the manual?
Questions and answers