SleepPhones Wireless Quick Start Quide

Quick Start Guide

WIRELESS CHARGING INSTRUCTIONS

Open the Velcro
module by unplugging it from the speakers. Plug the micro-USB cable into
the micro-USB port on the Bluetooth
of the cable into the USB port on your computer or any USB wall adaptor.
The Bluetooth
®
module in to charge, you will notice a blinking red light. The red light will
turn off when the Bluetooth
module will play for up to 13 hours.

PAIRING INSTRUCTIONS

Before pairing, fully charge your SleepPhones
Place your Bluetooth
Find the middle square button on the wireless Bluetooth
inside the headband.
Press and hold the square button for 5 full seconds until you hear an
ascending 3 ring tone followed by a series of beeps. The series of beeps
indicate that the module is in pairing mode.
Next, go into the Bluetooth
After a few seconds, "AcousticSheep" will appear in the list of devices. Click on
"AcousticSheep" to pair your device to the Bluetooth
long beep to indicate that it is paired with your device.
-OR-
Navigate to the Bluetooth
When "AcousticSheep" appears, click to pair your device to the Bluetooth
You will hear a long beep to indicate that it is paired with your device.
To watch our video on how to use SleepPhones
visit: www.SleepPhones.com/our-story/sleep-better-videos
The Bluetooth word mark and logos are registered
®
trademarks owned by Bluetooth
of such marks by AcousticSheep LLC are under license.
Other trademarks and trade names are those of their
respective owners.
in the back of the headband. Remove the Bluetooth
®
module comes with a partial charge. When you plug the
module is fully charged. A fully charged
®
device within 3 feet (1 meter) of your SleepPhones
®
settings on your device and turn on Bluetooth
®
connections menu on your Bluetooth
®
SIG, Inc., and any use
®
w ww.S lee pPh o ne s.c o m
module. Plug the standard USB end
®
Wireless headphones.
®
module. You will hear a
®
Wireless
®
.
®
module located
®
enabled device.
®
®
AS-SB-US-QUICK-03
®
.
®
module.