Advertisement
1. Push the handle into main body until it clicks into place.
2. Push the main body down into the floor attachment until it clicks into place.
3. Put the hard water filter down into the main body (on the main body behind where the tank
goes). The filter should be replaced every 6 months of use (see image below) .
4. Put the water tank down into the main body until it clicks into place.
Filling the Water Tank
1. Press the water tank release buttons and pull the water tank to remove
2. Pull the tap on the water tank cap to open
3. Fill the water tank with 13.5 oz. of water ,replace the cap and push firmly to close
4. Slide the water tank back into the machine until it clicks into place
Attaching the Floor Mop Pad
1. Set floor attachment in mop pad, making sure toggle is located on the back.
2. Pull the mop pad around the floor attachment all the way on all sides.
3. Tighten mop pad by pulling on elastic cord while pushing on toggle.
Starting the Unit
Twist the quick release cord wrap clockwise to unwrap the power cord completely and plug into a 120
Volt outlet as described on the Safety Instructions.
The indicator light will illuminate in red when the steam mop is plugged in, then turn to green after ten
seconds. When it turns green it is ready to steam.
NOTE: Upon first use of the steam mop or first use after refilling the water tank, the pump may
make a "knocking" sound. This is normal and should only last a few seconds. While in use, the
pump will continue to make a soft "knocking" sound. This is also normal.
With the proper attachments attached correctly the user may begin steaming by pulling and holding the
trigger.
7
Advertisement
