Alternatively, wear a discharging Wrist-strap device. (Be sure to remove it prior to applying power--this is an electric shock precaution.) Samsung Electronics...
Page 3
Always inspect for pinched, out- of-place, or frayed wiring. Do not change the spacing between components and the printed circuit board. Check the AC power cord for damage. Make sure that leads and components do not touch thermally hot parts. Samsung Electronics...
Page 4
Note : Accurate repair may not be possible due to external noise between the deck assÕy and main PCB. 2-1-2 Servicing Jig Jig Item Part No. X-5 Chassis Jig 68140-500-013 Connects the deck ass’y to the main PCB connecting cable. Samsung Electronics...
Page 5
9. If the test tape is ejected while the jig is in use, attempt to re-load the tape by simultaneously 6. Apply power to the function PCB. touching the start and end sensor LEDs. 7. Insert a test tape into the housing assÕy. Samsung Electronics...
CONNECTS TO THE MAIN PCB CN601. CONNECTS TO THE CAPSTAN MOTOR CONNECTOR OF DECK ASS'Y. CONNECTS TO THE LOADING MOTOR CONNECTOR OF DECK ASS'Y. DECK ASS'Y MAIN BOARD CN604 OPTION CN606 CN601 1 SCREW (1-3X10) 2 SCREWS (2-3X10) Samsung Electronics...
Page 7
Reference Information 2-2 IC Blocks 2-2-1 IC601 (KS88C8016) Samsung Electronics...
Page 8
Reference Information 2-2-2 IC301 (SS11501M) Samsung Electronics...
Page 9
Reference Information 2-2-3 IC302 (LA7411) Samsung Electronics...
Page 10
Reference Information 2-2-4 IC303 (SS23378M) Samsung Electronics...
Page 11
Reference Information MEMO Samsung Electronics...
Power Requirement AC 100 ~ 240V 50/60Hz, DC 12V (CAR BATTERY ONLY) Power Consumption Approx. 17 watts Operation Temperature 41°F-104°F (5°C-40°C) Operation Humidity 10%-75% Weight 4.0 Kg Dimensions (W x H x D) 360 x 92 x 309 mm Samsung Electronics...
Page 13
Product Specifications 3-2 Comparison Chart FUNCTION LINE RECORD REMARK MODEL SV-A10G SV-A11G SP-A10G SP-A11G SVR-17A SVR-17B SPR-17A SPR-17B Samsung Electronics...
4-1 Cabinet Assembly Note : Disassemble in the order shown. Reassemble in reverse order. 4-1-1 Top Cabinet removal 1. Remove 5 screws and slide the top cabinet to the rear to remove. REMOVE 5 SCREWS Fig. 4-1 Top Cabinet removal Samsung Electronics...
Page 15
Disassembly and Reassembly 4-1-2 Bottom cover removal 1. Remove 1 screw. 2. Lift up the bottom cover toward arrow ÒAÓ. SV-A10G/SP-A10G/SVR-17A/SPR-17A REMOVE 1 SCREW (BH;1-3X12 YELLOW) "A" LIFT UP THE BOTTOM COVER IN THE DIRECTION ARROW "A" SV-A11G/SP-A11G/SVR-17B/SPR-17B REMOVE 1 SCREW (BH;1-3X12 YELLOW)
Page 16
2. Release 4 hooks on the top side and 3 hooks on the bottom side and then, pull the assÕy front panel to remove. RELEASE 4 TABS (Top view) RELEASE 3 TABS (Bottom view) Fig. 4-3 Ass’y Front Panel removal Samsung Electronics...
Page 17
Disassembly and Reassembly 4-1-4 Ass’y Function removal 1. Release 5 hooks and remove the assÕy function. Note : Take extreme care not to damage the PCB when removing it. SV-A10G/SP-A10G/SVR-17A/SPR-17A RELEASE 4 TABS SV-A11G/SP-A11G/SVR-17B/SPR-17B RELEASE 4 TABS Fig. 4-4 Ass’y Function Removal...
CH-2 to TP7. 4. Adjust VR601 so that the head switching point is positioned 6.5 ± 0.5H from the V-SYNC left edge as shown. SW25HZ SWITCHING POINT PULSE CH-2 CH-1 VIDEO OUT 6.5H 0.5H (Main PCB - Component Side) Samsung Electronics...
Page 24
ACTION MODE EJECT EJECT CASSETTE IN CASSETTE IN UNLOAD UNLOAD R. PS R. PS, Z-R. PS R. SLOW PINCH ROLLER OFF POSITION STILL STILL PLAY PB, T-STOP, REC, PAUSE, F. PS, Z-FPS STOP STOP, POWER OFF FF/REW FF, REW Samsung Electronics...
Page 25
Alignment and Adjustment MEMO Samsung Electronics...
(TSEC LOCAL) S601A AC61-22321A HOLDER-TR;POM,-,-,-,-,- S602A AC61-22321A HOLDER-TR;POM,-,-,-,-,- SC301 AC63-42222A SHIELD-CASE P/AMP(AS;3516ET,T0.3,SIL,SV-80Z,- (TSEC LOCAL) Note : Location number 1, 21 are only for model SV-A10G/SVR-17A/CIS (SMSC, SALSC, SUSC). Please, refer to the separate information for the other models combind. Samsung Electronics...
Page 47
LED-IR;ROUND,5MM,150MW,5V,940NM,BK (TSEC LOCAL) QT01 0501-000534 TR-SMALL SIGNAL;2SC2412K,NPN,200MW,SOT-23,TP,1 (TSEC LOCAL) RT01 2007-000483 R-CHIP;1OHM,5%,1/10W,DA,TP,2012 (TSEC LOCAL) XT01 64539-102-311 CERAMIC RESONATOR;CSB455EBL/KBR455BKTL Note : ASSÕY REMOCON is only SV-A10G/CIS, SVR-17A. Please, refer to the separate information for the other models combind. 7-12 Samsung Electronics...
Important safety notices : Components identified with the mark ! have the special characteristics for safety. When replacing any of these components. Use only the same type. 3 Block Identification of Main PCB (Component Side) (Conductor Side) 11-2 Samsung Electronics...
Schematic Diagrams CAPSTAN SPEED CONTROL CYLINDER SPEED CONTROL 11-2 System Control/Servo CAPSTAN PHASE CONTROL CYLINDER PHASE CONTROL 11-4 Samsung Electronics...
Schematic Diagrams PB Y PROCESS REC Y PROCESS PB AUDIO PROCESS 11-3 Audio/Video PB C PROCESS REC C PROCESS REC AUDIO PROCESS Samsung Electronics 11-5...
Page 58
Schematic Diagrams PB VIDEO PROCESS REC VIDEO PROCESS 11-4 PB AUDIO PROCESS REC AUDIO PROCESS 11-6 Samsung Electronics...