Page 1
1000 Multi-Service Home Gateway User Operation Manual Version 1.1 KZ BROADBAND TECHNOLOGY Co. Ltd. C ONFIDENTIAL This document and the information contained in it is confidential information of KZ Broadband Technologies Ltd (KZ Tech), and shall not be used, or publish, or disclosed, or disseminated outside of KZ Tech in whole or in part without KZ Tech’s consent.
1000 User Operation Manual 1. Packing List The product is shipped with the following standard accessory and parts. The user should contact the local distributor if there is any part missing. Content Quantity Main System Unit 12V DC Power Adapter...
1000 User Operation Manual 3. Product Specification HYSICAL OICE ERVICE Dimensions 135mm (L) x 105mm (W) x 30mm (H) Basic Voices Weight < 300g Local and domestic and international long distance calls Power < 10 Watts Flexible dial plan configuration support...
4. Front Panel Description Table 1 Front Panel LED Specification Function Description Orange Color – Device is booting up Power supply indicator, Green Color – Device in normal operation dual color LED WAN port status LED Orange Color – Device WAN port is not yet ready for ( dual color) normal operation.
1000 User Operation Manual 5. Rear Panel Description Interface Function Description 12V DC Power connector DC Power Supply with harmonic suppression: 12V 1.5A. Reset Device Restart and Factory Press and immediate release: reboot the device. Default Reset Press and hold (10 seconds): Reset the device to factory default settings.
Explorer software for configuration of the device. If you are first time user, please access the WEB management interface via the LAN port. iSurf 1000 supports DHCP server and NAT function by default so the user only need to configure the PC network setting to use DHCP. The LAN PC can easily acquire its IP address from the device once the network setting is configured properly.
Page 7
1000 User Operation Manual user also has the option to navigate the configuration menu to complete the setup. For advanced user or system operator, the admin level WEB GUI management interface is available. It requires special admin password to gain full access of the device and configure the devices. Note admin level management function is not described in this manual.
1000 User Operation Manual Setup Wizard Select the “Setup Wizard” and click on the “Next” to enter Wizard welcome page as shown below. The quick Wizard setup is divided into four steps: Step 1: Configure WAN Networking ...
Page 9
1000 User Operation Manual PPPoE) to connect to Internet based on his access network type. If the user is not sure about the type of access type he should use, please consult with the service provider. For PPPoE dial up Internet access, the user will be required to configure the User name and Password for PPPoE dial up access.
Page 10
1000 User Operation Manual In this configuration page, the user requires to enter the SIP account and password information if he desires to configure the VoIP networking. The SIP server configuration will be performed by the network operator via admin management.
Page 11
1000 User Operation Manual Once the device restarts, please wait for a few minutes until the following windows appear again. The user may select “Advanced Self Setup” to quickly review and confirm the all setup. Click “Next” to proceed and enter the Self Setup menu as below.
Hereby, KZ Broadband Technologies, Ltd. declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. For the declaration of conformity, visit the Web site www.kztech.cn . Notice: Observe the national local regulations in the location where the device is to be used. This device may be...
Page 13
1000 User Operation Manual FCC Notice to user This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the iSurf 1000 and is the answer not in the manual?
Questions and answers